Search results
Results From The WOW.Com Content Network
Dots per inch. A close-up of the dots produced by an inkjet printer at draft quality. Actual size is approximately 1⁄4 by 1⁄4 inch (6 by 6 mm). Individual coloured droplets of ink are visible; this sample is about 150 DPI. Dots per inch ( DPI, or dpi[ 1]) is a measure of spatial printing, video or image scanner dot density, in particular ...
Scanners and cameras. "PPI" or "pixel density" may also describe image scanner resolution. In this context, PPI is synonymous with samples per inch. In digital photography, pixel density is the number of pixels divided by the area of the sensor. A typical DSLR, circa 2013, has 1–6.2 MP/cm 2; a typical compact has 20–70 MP/cm 2 .
Lines per inch ( LPI) is a measurement of printing resolution. A line consists of halftones that is built up by physical ink dots made by the printer device to create different tones. Specifically LPI is a measure of how close together the lines in a halftone grid are. The quality of printer device or screen determines how high the LPI will be.
The size of a screen is usually described by the length of its diagonal, which is the distance between opposite corners, usually in inches. It is also sometimes called the physical image size to distinguish it from the "logical image size," which describes a screen's display resolution and is measured in pixels.
Aspect ratio (image) The aspect ratio of an image is the ratio of its width to its height. It is expressed as two numbers separated by a colon, width:height. Common aspect ratios are 1.85:1 and 2.40:1 in cinematography, 4:3 and 16:9 in television, and 3:2 in still photography .
An image that is 2048 pixels in width and 1536 pixels in height has a total of 2048×1536 = 3,145,728 pixels or 3.1 megapixels. One could refer to it as 2048 by 1536 or a 3.1-megapixel image. The image would be a very low quality image (72ppi) if printed at about 28.5 inches wide, but a very good quality (300ppi) image if printed at about 7 ...
The display aspect ratio (DAR) is calculated from the physical width and height of a display, measured each in inch or cm ( Display size ). The pixel aspect ratio (PAR) is calculated from the width and height of one pixel. The storage aspect ratio (SAR) is calculated from the numbers of pixels in width and height stated in the display resolution.
The interlaced ( i or I) mode produced visible flickering of finer details, eventually fixable by use of scan doubler devices and VGA monitors. 720×480i/576i maximum. Typically 640×400i/512i or 640×200/256 NI, and 320×200/256 NI for games. 720.