Gamer.Site Web Search

  1. Ads

    related to: u section steel table height

Search results

  1. Results From The WOW.Com Content Network
  2. I-beam - Wikipedia

    en.wikipedia.org/wiki/I-beam

    In Australia, these steel sections are commonly referred to as Universal Beams (UB) or Columns (UC). The designation for each is given as the approximate height of the beam, the type (beam or column) and then the unit metre rate (e.g., a 460UB67.1 is an approximately 460 mm (18.1 in) deep universal beam that weighs 67.1 kg/m (135 lb/yd)). [6]

  3. List of tallest buildings in the United States - Wikipedia

    en.wikipedia.org/wiki/List_of_tallest_buildings...

    Also known as the Nordstrom Tower. At 1,550 feet, the tower is the tallest residential building in the world both by roof height and architectural height. [9] [10] Topped out in September 2019. [11] It is the tallest building outside Asia by roof height. Tallest building constructed in the United States in the 2020s. Willis Tower † Chicago

  4. Rail profile - Wikipedia

    en.wikipedia.org/wiki/Rail_profile

    The rail profile is the cross sectional shape of a railway rail, perpendicular to its length. Early rails were made of wood, cast iron or wrought iron. All modern rails are hot rolled steel with a cross section (profile) approximate to an I-beam, but asymmetric about a horizontal axis (however see grooved rail below).

  5. U.S. Steel Tower - Wikipedia

    en.wikipedia.org/wiki/U.S._Steel_Tower

    The U.S. Steel Tower, also known as the Steel Building, UPMC Building, or USX Tower (1988–2001), is a 64-story skyscraper at 600 Grant Street in downtown Pittsburgh, Pennsylvania. The interior has 2,300,000 sq ft (210,000 m 2) of leasable space.

  6. T-beam - Wikipedia

    en.wikipedia.org/wiki/T-beam

    T-beam. A T-beam (or tee beam ), used in construction, is a load-bearing structure of reinforced concrete, wood or metal, with a T -shaped cross section. The top of the T -shaped cross section serves as a flange or compression member in resisting compressive stresses. The web (vertical section) of the beam below the compression flange serves to ...

  7. Girder bridge - Wikipedia

    en.wikipedia.org/wiki/Girder_bridge

    A rolled steel girder is a girder that has been fabricated by rolling a blank cylinder of steel through a series of dies to create the desired shape. These create standardized I-beam and wide flange beam [ 7 ] shapes up to 100 feet in length.

  1. Ads

    related to: u section steel table height