Gamer.Site Web Search

Search results

1. Results From The WOW.Com Content Network

2. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Copper fittings for soldered joints. Pipe fittings: 1) Copper (solder); 2) Iron or brass (threaded); 3) Brass (compression); 4) Brass (compression to solder); 5) Brass adapters. PVC fittings. A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube ...

3. Pipe insulation - Wikipedia

   en.wikipedia.org/wiki/Pipe_insulation

   Pipe insulation made from rigid Phenolic, PIR, or PUR foam insulation is common in some countries. Rigid-foam insulation has minimal acoustic performance but can exhibit low thermal-conductivity values of 0.021 W/ (m·K) or lower, allowing energy-saving legislation to be met whilst using reduced insulation thicknesses.

4. Fusion bonded epoxy coating - Wikipedia

   en.wikipedia.org/wiki/Fusion_bonded_epoxy_coating

   Fusion bonded epoxy coating, also known as fusion-bond epoxy powder coating and commonly referred to as FBE coating, is an epoxy -based powder coating that is widely used to protect steel pipe used in pipeline construction from corrosion. It is also commonly used to protect reinforcing bars (though being phased out as of 2005 [ 1]) and on a ...

5. Thermowell - Wikipedia

   en.wikipedia.org/wiki/Thermowell

   A thermowell consists of a tube closed at one end and mounted on the wall of the piping or vessel within which the fluid of interest flows. A temperature sensor, such as a thermometer, thermocouple, or resistance temperature detector, is inserted in the open end of the tube, which is usually in the open air outside the piping or vessel and any ...

6. R-value (insulation) - Wikipedia

   en.wikipedia.org/wiki/R-value_(insulation)

   The R-value (in K ⋅ m 2/ W) is a measure of how well a two-dimensional barrier, such as a layer of insulation, a window or a complete wall or ceiling, resists the conductive [ 2] flow of heat, in the context of construction. [ 3]. R-value is the temperature difference per unit of heat flux needed to sustain one unit of heat flux between the ...

7. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   The most common process pipe joint is the butt weld. The ends of pipe to be welded must have a certain weld preparation called an End Weld Prep (EWP) which is typically at an angle of 37.5 degrees to accommodate the filler weld metal. The most common pipe thread in North America is the National Pipe Thread (NPT) or the Dryseal (NPTF