Search results
Results From The WOW.Com Content Network
Hot water reset, also called outdoor reset ( ODR ), is an energy-saving automatic control algorithm for heating boilers that are typically fired with fuel oil or natural gas. A hot water reset control loop measures the outside air temperature; this information is used to estimate demand or heating load as the outdoor temperature varies.
A thermostatic radiator valve on position 2 (15–17 °C) Installed thermostatic radiator valve with the adjustment wheel removed. A thermostatic radiator valve ( TRV) is a self-regulating valve fitted to hot water heating system radiator, to control the temperature of a room by changing the flow of hot water to the radiator.
A thermostatic mixing valve (TMV) is a valve that blends hot water with cold water to ensure constant, safe shower and bath outlet temperatures to prevent scalding . The storage of water at high temperature removes one possible breeding ground for Legionella; the use of a thermostat, rather than a static mixing valve, provides increased safety ...
A chiller boiler system is a hydronic system. It uses water instead of air to heat and cool a structure. A properly designed hydronic system is usually more efficient than a standard forced air system. [ 2] Chiller boiler systems use radiant heating and cooling or fan coil systems to condition a home or business.
Aquastat. An aquastat is a device used in hydronic heating systems for controlling water temperature. [1] [2] To prevent the boiler from firing too frequently, aquastats have a high limit temperature and a low limit. If the thermostat is calling for heat, the boiler will fire until the high limit is reached, then shut off (even if the ...
Water heating is a heat transfer process that uses an energy source to heat water above its initial temperature. Typical domestic uses of hot water include cooking, cleaning, bathing, and space heating. In industry, hot water and water heated to steam have many uses. Domestically, water is traditionally heated in vessels known as water heaters ...
However, boilers are normally installed with higher flow temperature by default because a domestic hot water cylinder is generally heated to 60 °C (140 °F), and this takes too long to achieve with a flow temperature only three degrees higher. Nevertheless, even partial condensing is more efficient than a traditional boiler.
The most common type of electrode boiler pumps water from the lower part of the vessel to an internal header that has nozzles that allow the water to flow to electrodes. Generally the working pressure is maintained at 10 bar. If more pressure is needed (more steam) the controls speed up the pump to increase flow through additional nozzles.