Search results
Results From The WOW.Com Content Network
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
ATEX Directive 2014/34/EU was published on 29 March 2014, by the European Parliament. It refers to the harmonization of the laws of the Member States relating to equipment and protective systems intended for use in potentially explosive atmospheres. Regarding ATEX 99/92/EC Directive, the requirement is that Employers must classify areas where ...
Intrinsic safety. Intrinsic safety (IS) is a protection technique for safe operation of electrical equipment in hazardous areas by limiting the energy, electrical and thermal, available for ignition. In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces ...
NFPA 704 safety squares on containers of ethyl alcohol and acetone. " NFPA 704: Standard System for the Identification of the Hazards of Materials for Emergency Response " is a standard maintained by the U.S. -based National Fire Protection Association. First "tentatively adopted as a guide" in 1960, [1] and revised several times since then, it ...
Maximum experimental safe gap (MESG) is a standardized measurement of how easily a gas flame will pass through a narrow gap bordered by heat-absorbing metal. MESG is used to classify flammable gases for the design and/or selection of electrical equipment in hazardous areas, and flame arrestor devices. [1] The National Electric Code classifies ...
Process Safety Management of Highly Hazardous Chemicals is a regulation promulgated by the U.S. Occupational Safety and Health Administration (OSHA). [1] It defines and regulates a process safety management (PSM) program for plants using, storing, manufacturing, handling or carrying out on-site movement of hazardous materials above defined amount thresholds.
The National Electrical Code (NEC), or NFPA 70, is a regionally adoptable standard for the safe installation of electrical wiring and equipment in the United States. It is part of the National Fire Code series published by the National Fire Protection Association (NFPA), a private trade association. [1] Despite the use of the term "national ...
Website. webstore.ansi.org /standards /nema /ansiz5352022-2475871. ANSI Z535 are American-developed standards designed to improve the identification of potential hazards to workers and/or property. The identifications are called Hazardous Communication (HazCom). ANSI Z535 sets the design and application standards for all HazCom used across ...