Search results
Results From The WOW.Com Content Network
The load index on a passenger-car tire is a numerical code stipulating the maximum load (mass, or weight) each tire can carry. For load range "B" tires, ETRTO (ISO-Metric) standards specify the load index rating at an inflation pressure of 36 psi (250 kPa) (table below), while P-Metric standards measure the load capacity at an inflation ...
Cold inflation pressure is the inflation pressure of tires before a car is driven and the tires (tyres) warmed up. Recommended cold inflation pressure is displayed on the owner's manual and on the placard (or sticker) attached to the vehicle door edge, pillar, glovebox door or fuel filler flap. Most passenger cars are recommended to have a tire ...
UTQG ratings (top) and tire code (bottom) on sidewall of Continental ContiProContact tire. Uniform Tire Quality Grading, commonly abbreviated as UTQG, is a set of standards for passenger car tires that measures a tire's treadwear, temperature resistance and traction. The UTQG was created by the National Highway Traffic Safety Administration in ...
The patient should remain in the ice bath until their body temperature falls to 102.2 degrees. Then, they can be transported to the hospital. Preparing for heat illness in a warming world
Central tire inflation system. Tractor-drawn trailer with CTIS. The Tatra T813 prototype had CTIS as early as 1960; it later became standard for all Tatra military trucks. A central tire inflation system ( CTIS) is a system to provide control over the air pressure in each of a vehicle's tires as a way to improve performance on different surfaces.
Direct TPMS, or direct tire pressure monitoring systems (direct sensor TPMS) refers to the use of a pressure sensor directly mounted on the wheels or tires of a vehicle. The pressure inside the tire is measured using a pressure transducer with the pressure information being subsequently sent to the vehicle to warn the driver of under or over inflation of a tire.
Tire uniformity. Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation, lateral force variation, conicity, ply steer, radial run-out, lateral ...
The circle of forces, traction circle, friction circle, [1] or friction ellipse [2] [3] [4] is a useful way to think about the dynamic interaction between a vehicle's tire and the road surface. The diagram below shows the tire from above, so that the road surface lies in the xy - plane. The vehicle to which the tire is attached is moving in the ...