Search results
Results From The WOW.Com Content Network
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
The third letter indicates the degree of summer heat—a indicates warmest month average temperature above 22 °C (71.6 °F) while b indicates warmest month averaging below 22 °C but with at least four months averaging above 10 °C (50.0 °F), and c indicates one to three months averaging above 10 °C (50.0 °F).
UN Regulation 37 covers motor vehicle filament lamps. These are categorized in three groups: those without general restriction that can be used in any application, those acceptable only for signalling lights (not for road illumination lamps), and those no longer allowable as light sources for new type approvals but still permitted for production as replacement parts.
a thermostat to control temperature by varying the amount of coolant going to the radiator; a fan to draw cool air through the radiator. The combustion process produces a large amount of heat. If heat were allowed to increase unchecked, detonation would occur, and components outside the engine would fail due to excessive temperature. To combat ...
To take a common example, 195/55R16 would mean that the nominal width of the tire is approximately 195 mm at the widest point, the height of the side-wall of the tire is 55% of the width (107 mm in this example) and that the tire fits 16-inch-diameter (410 mm) rims. The code gives a direct calculation of the theoretical diameter of the tire.
For example, the use of a standard state concentration of 10 −7 mol/L for the hydrogen ion in a real, aqueous solution is common in the field of biochemistry. [ 11 ] [ 12 ] In other application areas such as electrochemistry , the standard state is sometimes chosen as the actual state of the real solution at a standard concentration (often 1 ...
IP code. The IP code or ingress protection code indicates how well a device is protected against water and dust. It is defined by the International Electrotechnical Commission (IEC) under the international standard IEC 60529 [ 1] which classifies and provides a guideline to the degree of protection provided by mechanical casings and electrical ...
Temperature determines the statistical occupation of the microstates of the ensemble. The microscopic definition of temperature is only meaningful in the thermodynamic limit, meaning for large ensembles of states or particles, to fulfill the requirements of the statistical model. Kinetic energy is also considered as a component of thermal energy.