Search results
Results From The WOW.Com Content Network
Insulation system. The electrical insulation system for wires used in generators, electric motors, transformers, and other wire-wound electrical components is divided into different classes by temperature and temperature rise. The electrical insulation system is sometimes referred to as insulation class or thermal classification.
Class A is from 1.26 newton-seconds (conversion factor 4.448 N per lb. force) to 2.5 N·s, and each class is then double the total impulse of the preceding class, with Class B being 2.51 to 5.00 N·s. The letter ( M) would represent the total impulse of between 5,120.01 and 10,240.00 N·s of impulse. Motors E and below are considered low power ...
Various regulations use terms such as class, division, zone, and group to differentiate the various hazards. Often an area classification plan view is provided to identify equipment ratings and installation techniques to be used for each classified area. The plan may contain the list of chemicals with their group and temperature rating.
The numbers of older IEC standards were converted in 1997 by adding 60000; for example IEC 27 became IEC 60027. IEC standards often have multiple sub-part documents; only the main title for the standard is listed here. IEC 60027 Letter symbols to be used in electrical technology; IEC 60028 International standard of resistance for copper
This is the rating required to protect microfilm, microfiche, and other film-based information storage media. Above 150 °F (65.5 °C) film is distorted by the heat and information is lost. A Class 150-2 Hour vault must keep the temperature below 150 °F. for at least two hours, with temperatures up to 2,000 °F. (1,093.3 °C) outside the vault.
A comparison of how effective the subsonic inlet is at compressing air compared with the fan is given by inlet ram and fan temperature rises for a CFM56 of about 30 and 40 °F at 0.85 Mn cruise. [3] Temperature rise is connected to pressure rise by the losses incurred in the way the compression is achieved and all three are visually apparent on ...
A combustible material is a material that can burn (i.e., sustain a flame) in air under certain conditions. A material is flammable if it ignites easily at ambient temperatures. In other words, a combustible material ignites with some effort and a flammable material catches fire immediately on exposure to flame.
The spectral type is formed by the letter S and a number between zero and ten. This number corresponds to the temperature of the star and approximately follows the temperature scale used for class M giants. The most common types are S3 to S5. The non-standard designation S10 has only been used for the star Chi Cygni when at an extreme minimum.