Search results
Results From The WOW.Com Content Network
Network interface device. In telecommunications, a network interface device ( NID; also known by several other names) is a device that serves as the demarcation point between the carrier's local loop and the customer's premises wiring. Outdoor telephone NIDs also provide the subscriber with access to the station wiring and serve as a convenient ...
Static routing. Static routing is a form of routing that occurs when a router uses a manually-configured routing entry, rather than information from dynamic routing traffic. [1] In many cases, static routes are manually configured by a network administrator by adding in entries into a routing table, though this may not always be the case. [2]
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
Enhanced Interior Gateway Routing Protocol. Enhanced Interior Gateway Routing Protocol ( EIGRP) is an advanced distance-vector routing protocol that is used on a computer network for automating routing decisions and configuration. The protocol was designed by Cisco Systems as a proprietary protocol, available only on Cisco routers.
e. The Spanning Tree Protocol ( STP) is a network protocol that builds a loop-free logical topology for Ethernet networks. The basic function of STP is to prevent bridge loops and the broadcast radiation that results from them. Spanning tree also allows a network design to include backup links providing fault tolerance if an active link fails.
The T-carrier is a hardware specification for carrying multiple time-division multiplexed (TDM) telecommunications channels over a single four-wire transmission circuit. It was developed by AT&T at Bell Laboratories ca. 1957 and first employed by 1962 for long-haul pulse-code modulation (PCM) digital voice transmission with the D1 channel bank .
In network routing, the control plane is the part of the router architecture that is concerned with establishing the network topology, or the information in a routing table that defines what to do with incoming packets. Control plane functions, such as participating in routing protocols, run in the architectural control element. [1]
Router (computing) A router [a] is a computer and networking device that forwards data packets between computer networks, including internetworks such as the global Internet. [2] [3] [4] A router is connected to two or more data lines from different IP networks. When a data packet comes in on a line, the router reads the network address ...