Search results
Results From The WOW.Com Content Network
A binary-to-text encoding is encoding of data in plain text. More precisely, it is an encoding of binary data in a sequence of printable characters. These encodings are necessary for transmission of data when the communication channel does not allow binary data (such as email or NNTP) or is not 8-bit clean. PGP documentation ( RFC 4880) uses ...
This encoding was not satisfactory on performance grounds, among other problems, and the biggest problem was probably that it did not have a clear separation between ASCII and non-ASCII: new UTF-1 tools would be backward compatible with ASCII-encoded text, but UTF-1-encoded text could confuse existing code expecting ASCII (or extended ASCII ...
Binary translation. In computing, binary translation is a form of binary recompilation where sequences of instructions are translated from a source instruction set to the target instruction set. In some cases such as instruction set simulation, the target instruction set may be the same as the source instruction set, providing testing and ...
A binary number is a number expressed in the base -2 numeral system or binary numeral system, a method for representing numbers that uses only two symbols for the natural numbers: typically "0" ( zero) and "1" ( one ). A binary number may also refer to a rational number that has a finite representation in the binary numeral system, that is, the ...
This is a list of file signatures, data used to identify or verify the content of a file. Such signatures are also known as magic numbersor Magic Bytes. Many file formats are not intended to be read as text. If such a file is accidentally viewed as a text file, its contents will be unintelligible. However, some file signatures can be ...
A 1-of-n binary decoder has n output bits. This type of decoder asserts exactly one of its n output bits, or none of them, for every integer input value. The "address" (bit number) of the activated output is specified by the integer input value. For example, output bit number 0 is selected when the integer value 0 is applied to the inputs.
Logic level. In digital circuits, a logic level is one of a finite number of states that a digital signal can inhabit. Logic levels are usually represented by the voltage difference between the signal and ground, although other standards exist. The range of voltage levels that represent each state depends on the logic family being used.
The value represented by a redundant digit can be found using a translation table. This table indicates the mathematical value of each possible pair of bits. As in conventional binary representation, the integer value of a given representation is a weighted sum of the values of the digits. The weight starts at 1 for the rightmost position and ...