Search results
Results From The WOW.Com Content Network
The load index on a passenger-car tire is a numerical code stipulating the maximum load (mass, or weight) each tire can carry. For load range "B" tires, ETRTO (ISO-Metric) standards specify the load index rating at an inflation pressure of 36 psi (250 kPa) (table below), while P-Metric standards measure the load capacity at an inflation ...
UTQG ratings (top) and tire code (bottom) on sidewall of Continental ContiProContact tire. Uniform Tire Quality Grading, commonly abbreviated as UTQG, is a set of standards for passenger car tires that measures a tire's treadwear, temperature resistance and traction. The UTQG was created by the National Highway Traffic Safety Administration in ...
Cold inflation pressure is the inflation pressure of tires before a car is driven and the tires (tyres) warmed up. Recommended cold inflation pressure is displayed on the owner's manual and on the placard (or sticker) attached to the vehicle door edge, pillar, glovebox door or fuel filler flap. Most passenger cars are recommended to have a tire ...
Temperature: with both solid and pneumatic tires, rolling resistance has been found to decrease as temperature increases (within a range of temperatures: i.e. there is an upper limit to this effect) [59] [60] For a rise in temperature from 30 °C to 70 °C the rolling resistance decreased by 20-25%. [61]
Converting units of temperature differences (also referred to as temperature deltas) is not the same as converting absolute temperature values, and different formulae must be used. To convert a delta temperature from degrees Fahrenheit to degrees Celsius, the formula is {ΔT}°F = 9 5 {ΔT}°C. To convert a delta temperature from degrees ...
Direct TPMS, or direct tire pressure monitoring systems (direct sensor TPMS) refers to the use of a pressure sensor directly mounted on the wheels or tires of a vehicle. The pressure inside the tire is measured using a pressure transducer with the pressure information being subsequently sent to the vehicle to warn the driver of under or over inflation of a tire.
Off-roading tires may use a different measurement scheme: Tread width × Outside diameter, followed by wheel size (all in inches) – for example 31×10.50R15 (787 mm × 267 mm R380 in metric designation). The size of the wheel, however, is denoted as 8.5 in × 20.0 in (220 mm × 510 mm).
The conversion between different SI units for one and the same physical quantity is always through a power of ten. This is why the SI (and metric systems more generally) are called decimal systems of measurement units. [10] The grouping formed by a prefix symbol attached to a unit symbol (e.g. ' km ', ' cm ') constitutes a new inseparable unit ...