Search results
Results From The WOW.Com Content Network
Water heating is a heat transfer process that uses an energy source to heat water above its initial temperature. Typical domestic uses of hot water include cooking, cleaning, bathing, and space heating. In industry, hot water and water heated to steam have many uses. Domestically, water is traditionally heated in vessels known as water heaters ...
Because boiler feed water from cogeneration plants has much lower return rates than 100% condensing power plants, industries usually have to treat proportionately more boiler make up water. Boiler feed water must be completely oxygen free and de-mineralized, and the higher the pressure the more critical the level of purity of the feed water. [5]
Hot water reset, also called outdoor reset ( ODR ), is an energy-saving automatic control algorithm for heating boilers that are typically fired with fuel oil or natural gas. A hot water reset control loop measures the outside air temperature; this information is used to estimate demand or heating load as the outdoor temperature varies.
The purpose of the air preheater is to recover the heat from the boiler flue gas which increases the thermal efficiency of the boiler by reducing the useful heat lost in the flue gas. As a consequence, the flue gases are also conveyed to the flue gas stack (or chimney) at a lower temperature, allowing simplified design of the conveyance system ...
Thermal power station. A thermal power station, also known as a thermal power plant, is a type of power station in which the heat energy generated from various fuel sources (e.g., coal, natural gas, nuclear fuel, etc.) is converted to electrical energy. [ 1] The combustion or nuclear reaction of the fuel source in a boiler or reactor generates ...
Temperature control valves are used to blend hot supply water into the return to avoid thermal shock or condensation inside of the boiler. The lower the return temperature to the boiler the more likely it will be in condensing mode. If the return temperature is kept below approximately 55 °C (131 °F), the boiler should still be in condensing ...
Boiler (power generation) An industrial boiler, originally used for supplying steam to a stationary steam engine. A boiler or steam generator is a device used to create steam by applying heat energy to water. Although the definitions are somewhat flexible, it can be said that older steam generators were commonly termed boilers and worked at low ...
The major difference between the multitubular and water-tube condenser was that in the former the water passed outside and around the tubes which carry the hot gas, and in the latter type, the opposite was the case. Thus when only muddy water pumped from rivers or canals was available; the water-tube condenser was used.