Search results
Results From The WOW.Com Content Network
For example, a conventional heat pump system used to heat a building in Montana's −57 °C (−70 °F) low temperature or cool a building in the highest temperature ever recorded in the US—57 °C (134 °F) in Death Valley, California, in 1913 would require a large amount of energy due to the extreme difference between inside and outside air ...
A number of homes and small apartment buildings have demonstrated combining a large internal water tank for heat storage with roof-mounted solar-thermal collectors. Storage temperatures of 90 °C (194 °F) are sufficient to supply both domestic hot water and space heating. The first such house was MIT Solar House #1, in 1939.
Underfloor heating and cooling is a form of central heating and cooling that achieves indoor climate control for thermal comfort using hydronic or electrical heating elements embedded in a floor. Heating is achieved by conduction, radiation and convection. Use of underfloor heating dates back to the Neoglacial and Neolithic periods.
The balance point temperature is mathematically defined as: Equation 1: tbalance = tthermostat - Q IHG + Q SOL U bldg. Where: tbalance is the balance point outdoor air temperature, given in °C (°F). tThermostat is the building thermostat set-point temperature, given in °C (°F). QIHG is the internal heat generation rate per unit floor ...
Typical domestic exposures are of approximately 100 Bq/m 3 (2.7 pCi/L) indoors. Some level of radon will be found in all buildings. Radon mostly enters a building directly from the soil through the lowest level in the building that is in contact with the ground. High levels of radon in the water supply can also increase indoor radon air levels.
A ground-coupled heat exchanger is an underground heat exchanger that can capture heat from and/or dissipate heat to the ground. They use the Earth's near constant subterranean temperature to warm or cool air or other fluids for residential, agricultural or industrial uses. If building air is blown through the heat exchanger for heat recovery ...
The typical range for conventional boilers is to vary the supply water temperature from 60 to 82 °C (140 to 180 °F) as the outside temperature varies from 18 to −18 °C (64 to 0 °F). Buildings cool down slowly when the outdoor temperature is moderate, and cool more rapidly when the outdoor temperature is colder. Hot water reset reduces the ...
Thermal energy storage ( TES) is the storage of thermal energy for later reuse. Employing widely different technologies, it allows surplus thermal energy to be stored for hours, days, or months. Scale both of storage and use vary from small to large – from individual processes to district, town, or region.