Search results
Results From The WOW.Com Content Network
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
Automatic transmission fluid (ATF) is a hydraulic fluid that is essential for the proper functioning of vehicles equipped with automatic transmissions. Usually, it is coloured red or green to differentiate it from motor oil and other fluids in the vehicle. This fluid is designed to meet the unique demands of an automatic transmission.
Cold inflation pressure is the inflation pressure of tires before a car is driven and the tires (tyres) warmed up. Recommended cold inflation pressure is displayed on the owner's manual and on the placard (or sticker) attached to the vehicle door edge, pillar, glovebox door or fuel filler flap. Most passenger cars are recommended to have a tire ...
To take a common example, 195/55R16 would mean that the nominal width of the tire is approximately 195 mm at the widest point, the height of the side-wall of the tire is 55% of the width (107 mm in this example) and that the tire fits 16-inch-diameter (410 mm) rims. The code gives a direct calculation of the theoretical diameter of the tire.
Car engine thermostat. Perhaps the most common example of purely mechanical thermostat technology in use today is the internal combustion engine cooling system thermostat, used to maintain the engine near its optimum operating temperature by regulating the flow of coolant to an air-cooled radiator. This type of thermostat operates using a ...
A vehicle identification number ( VIN; also called a chassis number or frame number) is a unique code, including a serial number, used by the automotive industry to identify individual motor vehicles, towed vehicles, motorcycles, scooters and mopeds, as defined by the International Organization for Standardization in ISO 3779 (content and ...
The codes are in the form of two letters and/or digits which are appended to the aircraft's model designator, as seen in the following examples: A Boeing 377-10 ordered by Pan American World Airways with customer code 26 [note 1] would be designated 337-10-26. [1] A Boeing 707-100 ordered by Qantas with customer code 38 would be designated as ...
Tornado intensity is the measure of wind speeds and potential risk produced by a tornado. Intensity can be measured by in situ or remote sensing measurements, but since these are impractical for wide-scale use, intensity is usually inferred by proxies, such as damage. The Fujita scale, Enhanced Fujita scale, and the International Fujita scale ...