Search results
Results From The WOW.Com Content Network
Has an ATmega328 with Arduino bootloader, a dual H-bridge and additional prototyping space and headers. It is compatible with many shields, though four digital pins are used when operating the motor controller. Has an onboard voltage regulator, additional LEDs, a temperature sensor, and a light sensor. Part of the DFRobotShop Rover kit ...
PIC (usually pronounced as /pɪk/) is a family of microcontrollers made by Microchip Technology, derived from the PIC1640 [ 1][ 2] originally developed by General Instrument 's Microelectronics Division. The name PIC initially referred to Peripheral Interface Controller, [ 3] and is currently expanded as Programmable Intelligent Computer. [ 4]
In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED. The voltage drop across a lit LED is approximately constant over a wide range of ...
The silicon bandgap temperature sensor is an extremely common form of temperature sensor ( thermometer) used in electronic equipment. Its main advantage is that it can be included in a silicon integrated circuit at very low cost. The principle of the sensor is that the forward voltage of a silicon diode, which may be the base-emitter junction ...
DA (or DA−) Digital Addressable Lighting Interface ( DALI) is a trademark for network-based products that control lighting. The underlying technology was established by a consortium of lighting equipment manufacturers as a successor for 1-10 V/ 0–10 V lighting control systems, and as an open standard alternative to several proprietary ...
Has an ATmega328 with Arduino bootloader, a dual H-bridge and additional prototyping space and headers. It is compatible with many shields, though four digital pins are used when operating the motor controller. Has an onboard voltage regulator, additional LEDs, a temperature sensor, and a light sensor. Part of the DFRobotShop Rover kit ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...
Thermal management of high-power LEDs. Typical thermal model of LED package. LED power dissipation is modeled as a current source; thermal resistance is modeled as a resistor; and the ambient temperature is modeled as a voltage source. High power light-emitting diodes (LEDs) can use 350 milliwatts or more in a single LED.