Search results
Results From The WOW.Com Content Network
Double dabble. In computer science, the double dabble algorithm is used to convert binary numbers into binary-coded decimal (BCD) notation. [ 1][ 2] It is also known as the shift-and-add -3 algorithm, and can be implemented using a small number of gates in computer hardware, but at the expense of high latency. [ 3]
Decimal: 9 1. Binary : 1001 0001. Hence the numerical range for one unpacked BCD byte is zero through nine inclusive, whereas the range for one packed BCD byte is zero through ninety-nine inclusive. To represent numbers larger than the range of a single byte any number of contiguous bytes may be used.
Densely packed decimal (DPD) is an efficient method for binary encoding decimal digits.. The traditional system of binary encoding for decimal digits, known as binary-coded decimal (BCD), uses four bits to encode each digit, resulting in significant wastage of binary data bandwidth (since four bits can store 16 states and are being used to store only 10), even when using packed BCD.
A ternary / ˈtɜːrnəri / numeral system (also called base 3 or trinary) has three as its base. Analogous to a bit, a ternary digit is a trit ( tri nary dig it ). One trit is equivalent to log 2 3 (about 1.58496) bits of information . Although ternary most often refers to a system in which the three digits are all non–negative numbers ...
Six-bit BCD code was the adaptation of the punched card code to binary code. IBM applied the terms binary-coded decimal and BCD to the variations of BCD alphamerics used in most early IBM computers, including the IBM 1620, IBM 1400 series, and non-decimal architecture members of the IBM 700/7000 series.
e. BCD ( binary-coded decimal ), also called alphanumeric BCD, alphameric BCD, BCD Interchange Code, [ 1] or BCDIC, [ 1] is a family of representations of numerals, uppercase Latin letters, and some special and control characters as six-bit character codes . Unlike later encodings such as ASCII, BCD codes were not standardized.
The Intel BCD opcodes are a set of six x86 instructions that operate with binary-coded decimal numbers. The radix used for the representation of numbers in the x86 processors is 2. This is called a binary numeral system. However, the x86 processors do have limited support for the decimal numeral system . In addition, the x87 part supports a ...
In digital electronics, a binary decoder is a combinational logic circuit that converts binary information from the n coded inputs to a maximum of 2 n unique outputs. They are used in a wide variety of applications, including instruction decoding, data multiplexing and data demultiplexing, seven segment displays, and as address decoders for memory and port-mapped I/O.