Search results
Results From The WOW.Com Content Network
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
In radar -related subjects and in JTIDS, a data mile is a unit of distance equal to 6000 feet (1.8288 kilometres or 0.987 nautical miles ). An international mile is exactly 0.88 of a data mile. The speed of light is 983571056 ft/s, or about one foot per nanosecond. If it were exactly one foot per nanosecond, and a target was one data mile away ...
Geographic coordinate conversion has applications in cartography, surveying, navigation and geographic information systems . In geodesy, geographic coordinate conversion is defined as translation among different coordinate formats or map projections all referenced to the same geodetic datum. [ 1] A geographic coordinate transformation is a ...
Flight levels [3] are described by a number, which is the nominal altitude, or pressure altitude, in hundreds of feet, while being a multiple of 500 ft. Therefore, a pressure altitude of 32,000 ft (9,800 m) is referred to as "flight level 320". In metre altitudes the format is Flight Level xx000 metres.
A geoid is needed to convert the 3D position to sea-level elevation. Pressure altimeter measuring atmospheric pressure, which decreases as altitude increases. Since atmospheric pressure varies with the weather, too, a recent local measure of the pressure at a known altitude is needed to calibrate the altimeter. Stereoscopy in aerial photography.
For petroleum gases, the standard cubic foot (scf) is defined as one cubic foot of gas at 60 °F (288.7 K; 15.56 °C) and at normal sea level air pressure. The pressure definition differs between sources, but are all close to normal sea level air pressure. A pressure of 14.696 pounds per square inch (1.00000 atm; 101.325 kPa ). [ 2]
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m ). [ 13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd ...