Search results
Results From The WOW.Com Content Network
An operating temperature is the allowable temperature range of the local ambient environment at which an electrical or mechanical device operates. The device will operate effectively within a specified temperature range which varies based on the device function and application context, and ranges from the minimum operating temperature to the maximum operating temperature (or peak operating ...
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
Motor velocity constant, back EMF constant. is the motor velocity, or motor speed, [2] constant (not to be confused with kV, the symbol for kilovolt ), measured in revolutions per minute (RPM) per volt or radians per volt second, rad/V·s: [3] The rating of a brushless motor is the ratio of the motor's unloaded rotational speed (measured in RPM ...
Motor-CAD is an Electromagnetic and Thermal analysis package for electric motors and generators, developed and sold by Motor Design Ltd. It was initially released in 1999. Modules are available for brushless permanent magnet motors (BPM), outer rotor BPM motors, induction motors, permanent magnet dc machines, switched reluctance motors ...
Model rocket motor classification. Motors for model rockets [1] and high-powered rockets [2] (together, consumer rockets) are classified by total impulse into a set of letter-designated ranges, from ⅛ A up to O . The total impulse is the integral of the thrust over burn time. Where is the burn time in seconds, is the instantaneous thrust in ...
Neher–McGrath method. In electrical engineering, Neher–McGrath is a method of estimating the steady-state temperature of electrical power cables for some commonly encountered configurations. By estimating the temperature of the cables, the safe long-term current-carrying capacity of the cables can be calculated.
A rotary phase converter, abbreviated RPC, is an electrical machine that converts power from one polyphase system to another, converting through rotary motion. Typically, single-phase electric power is used to produce three-phase electric power locally to run three-phase loads in premises where only single-phase is available.
Integrated circuit sensors. The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus / I 2 C or 1-Wire . In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware ...