Search results
Results From The WOW.Com Content Network
1 Control-C has typically been used as a "break" or "interrupt" key. 2 Control-D has been used to signal "end of file" for text typed in at the terminal on Unix / Linux systems. Windows, DOS, and older minicomputers used Control-Z for this purpose. 3 Control-G is an artifact of the days when teletypes were in use.
Braille ASCII. Braille ASCII (or more formally The North American Braille ASCII Code, also known as SimBraille) is a subset of the ASCII character set which uses 64 of the printable ASCII characters to represent all possible dot combinations in six-dot braille. It was developed around 1969 and, despite originally being known as North American ...
A binary number is a number expressed in the base -2 numeral system or binary numeral system, a method for representing numbers that uses only two symbols for the natural numbers: typically "0" ( zero) and "1" ( one ). A binary number may also refer to a rational number that has a finite representation in the binary numeral system, that is, the ...
Unicode, formally The Unicode Standard, [ note 1] is a text encoding standard maintained by the Unicode Consortium designed to support the use of text in all of the world's writing systems that can be digitized. Version 15.1 of the standard [ A] defines 149 813 characters [ 3] and 161 scripts used in various ordinary, literary, academic, and ...
A binary-to-text encoding is encoding of data in plain text. More precisely, it is an encoding of binary data in a sequence of printable characters. These encodings are necessary for transmission of data when the communication channel does not allow binary data (such as email or NNTP) or is not 8-bit clean. PGP documentation ( RFC 4880) uses ...
This is a list of some binary codes that are (or have been) used to represent text as a sequence of binary digits "0" and "1". Fixed-width binary codes use a set number of bits to represent each character in the text, while in variable-width binary codes, the number of bits may vary from character to character.
The atree or Binary Ahnentafel method is based on the same numbering of nodes, but first converts the numbers to binary notation and then converts each 0 to M (for Male) and each 1 to F (for Female). The first character of each code (shown as X in the table below) is M if the subject is male and F if the subject is female.
Double dabble. In computer science, the double dabble algorithm is used to convert binary numbers into binary-coded decimal (BCD) notation. [1] [2] It is also known as the shift-and-add -3 algorithm, and can be implemented using a small number of gates in computer hardware, but at the expense of high latency. [3]