Search results
Results From The WOW.Com Content Network
Alt code. On personal computers with numeric keypads that use Microsoft operating systems, such as Windows, many characters that do not have a dedicated key combination on the keyboard may nevertheless be entered using the Alt code (the Alt numpad input method ). This is done by pressing and holding the Alt key, then typing a number on the ...
A telephone keypad using the ITU E.161 standard. A telephone keypad is a keypad installed on a push-button telephone or similar telecommunication device for dialing a telephone number. It was standardized when the dual-tone multi-frequency signaling (DTMF) system was developed in the Bell System in the United States in the 1960s that replaced ...
To use the shortcut, turn on NumLock / Fn, and make sure the cursor is flashing where you want the symbol to go. Press and hold the alt key, and then press numbers. You don’t need to press the ...
This page lists codes for keyboard characters, the computer code values for common characters, such as the Unicode or HTML entity codes (see below: Table of HTML values "). There are also key chord combinations, such as keying an en dash ('–') by holding ALT+0150 on the numeric keypad of MS Windows computers.
When Num Lock is on, digit keys produce the corresponding digit. On Apple Macintosh computers, which lack a Num Lock key, the numeric keypad always produces only numbers; the Num Lock key is replaced by the Clear key. The arrangement of digits on numeric keypads with the 7-8-9 keys two rows above the 1-2-3 keys is derived from calculators and ...
The most commonly encountered are the "XT" ("set 1") scancodes, based on the 83-key keyboard used by the IBM PC XT and earlier. These mostly consist of a single byte; the low 7 bits identify the key, and the most significant bit is clear for a key press or set for a key release. Some additional keys have an E0 (or rarely, E1 or E2) prefix.
1 Control-C has typically been used as a "break" or "interrupt" key. 2 Control-D has been used to signal "end of file" for text typed in at the terminal on Unix / Linux systems. Windows, DOS, and older minicomputers used Control-Z for this purpose. 3 Control-G is an artifact of the days when teletypes were in use.
Key types A typical 105-key computer keyboard, consisting of sections with different types of keys. A computer keyboard consists of alphanumeric or character keys for typing, modifier keys for altering the functions of other keys, navigation keys for moving the text cursor on the screen, function keys and system command keys—such as Esc and Break—for special actions, and often a numeric ...