Gamer.Site Web Search

Search results

1. Results From The WOW.Com Content Network

2. Electrical equipment in hazardous areas - Wikipedia

   en.wikipedia.org/wiki/Electrical_equipment_in...

   In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...

3. Heating, ventilation, and air conditioning - Wikipedia

   en.wikipedia.org/wiki/Heating,_ventilation,_and...

   For example, a conventional heat pump system used to heat a building in Montana's −57 °C (−70 °F) low temperature or cool a building in the highest temperature ever recorded in the US—57 °C (134 °F) in Death Valley, California, in 1913 would require a large amount of energy due to the extreme difference between inside and outside air ...

4. Register (air and heating) - Wikipedia

   en.wikipedia.org/wiki/Register_(air_and_heating)

   A floor register. A register is a grille with moving parts, capable of being opened and closed and the air flow directed, which is part of a building's heating, ventilation, and air conditioning (HVAC) system. The placement and size of registers is critical to HVAC efficiency. Register dampers are also important, and can serve a safety function.

5. Heating seasonal performance factor - Wikipedia

   en.wikipedia.org/wiki/Heating_seasonal...

   HSPF is defined as the ratio of heat output (measured in BTUs) over the heating season to electricity used (measured in watt-hours ). [1] [2] It therefore has units of BTU/watt-hr. The higher the HSPF rating of a unit, the more energy efficient it is. An electrical resistance heater, which is not considered efficient, has an HSPF of 3.41.

6. List of IEC standards - Wikipedia

   en.wikipedia.org/wiki/List_of_IEC_standards

   IEC 60227 Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. IEC 60228 Conductors of insulated cables. IEC 60229 Electric cables – Tests on extruded over-sheaths with a special protective function. IEC 60230 Impulse tests on cables and their accessories.

7. Industrial furnace - Wikipedia

   en.wikipedia.org/wiki/Industrial_furnace

   Ceramic fibre is commonly used for the roof and wall of the furnace and is graded by its density and then its maximum temperature rating. For example, 8# 2,300 °F means 8 lb/ft 3 density with a maximum temperature rating of 2,300 °F. The actual service temperature rating for ceramic fiber is a bit lower than the maximum rated temperature.