Search results
Results From The WOW.Com Content Network
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
ATEX Directive 2014/34/EU was published on 29 March 2014, by the European Parliament. It refers to the harmonization of the laws of the Member States relating to equipment and protective systems intended for use in potentially explosive atmospheres. Regarding ATEX 99/92/EC Directive, the requirement is that Employers must classify areas where ...
Georgia. The U.S. state of Georgia first required its residents to register their motor vehicles and display license plates in 1910. Plates are currently issued by the Motor Vehicle Division of the Georgia Department of Revenue. Only rear plates have been required since 1942.
Combustibility and flammability. A combustible material is a material that can burn (i.e., sustain a flame) in air under certain conditions. A material is flammable if it ignites easily at ambient temperatures. In other words, a combustible material ignites with some effort and a flammable material catches fire immediately on exposure to flame.
UN Regulation 37 covers motor vehicle filament lamps. These are categorized in three groups: those without general restriction that can be used in any application, those acceptable only for signalling lights (not for road illumination lamps), and those no longer allowable as light sources for new type approvals but still permitted for production as replacement parts.
6061 sheet in the T4 condition can be formed with limited ductility in the cold state. For deep draw and complex shapes, and for the avoidance of spring-back, an aluminium hot stamping process ( Hot Form Quench ) can be used, which forms a blank at a elevated temperature (~ 550 C) in a cooled die, leaving a part in W-temper condition before ...
Standard state. The standard state of a material (pure substance, mixture or solution) is a reference point used to calculate its properties under different conditions. A degree sign (°) or a superscript Plimsoll symbol ( ⦵) is used to designate a thermodynamic quantity in the standard state, such as change in enthalpy (Δ H °), change in ...
The IP code or ingress protection code indicates how well a device is protected against water and dust. It is defined by the International Electrotechnical Commission (IEC) under the international standard IEC 60529 [ 1 ] which classifies and provides a guideline to the degree of protection provided by mechanical casings and electrical ...