Search results
Results From The WOW.Com Content Network
Identification friend or foe. Identification, friend or foe ( IFF) is a combat identification system designed for command and control. It uses a transponder that listens for an interrogation signal and then sends a response that identifies the broadcaster. IFF systems usually use radar frequencies, but other electromagnetic frequencies, radio ...
0041–0057. Belgium. Assigned for VFR traffic under Flight Information Services (BXL FIC). [citation needed] 0100. Australia. Flights operating at aerodromes (in lieu of codes 1200, 2000 or 3000 when assigned by ATC or noted in the Enroute Supplement). [6] 0100–0400.
A transponder (short for trans mitter-res ponder [1] and sometimes abbreviated to XPDR, [2] XPNDR, [3] TPDR [4] or TP [5]) is an electronic device that produces a response when it receives a radio-frequency interrogation. Aircraft have transponders to assist in identifying them on air traffic control radar. Collision avoidance systems have been ...
Mode 3/A is often combined with Mode C to provide altitude information as well. C: Provides the aircraft's pressure altitude and is usually combined with Mode 3/A to provide a combination of a 4-digit octal code and altitude as Mode 3 A/C, often referred to as Mode A and C: 4: Provides a 3-pulse reply, delay is based on the encrypted challenge: 5
E-ZPass tollbooths, like this one on the Pennsylvania Turnpike in Bensalem Township, Pennsylvania, use transponders to bill motorists. Electronic toll collection ( ETC) is a wireless system to automatically collect the usage fee or toll charged to vehicles using toll roads, HOV lanes, toll bridges, and toll tunnels. [1]
The transponder has a small required set of controls and is simple to operate. It has a method to enter the four-digit transponder code, also known as a beacon code or squawk code, and a control to transmit an ident, which is done at the controller's request (see SPI pulse below). Transponders typically have 4 operating modes: Off, Standby, On ...
ISO / IEC 18000-3 [1] is an international standard for passive RFID item level identification and describes the parameters for air interface communications at 13.56 MHz. The target markets for MODE 2 are in tagging systems for manufacturing, logistics, retail, transport and airline baggage. MODE 2 is especially suitable for high speed bulk ...
In aviation, ACARS ( / ˈeɪkɑːrz /; an acronym for Aircraft Communications Addressing and Reporting System) is a digital datalink system for transmission of short messages between aircraft and ground stations via airband radio or satellite. The protocol was designed by ARINC and deployed in 1978, [1] using the Telex format.