Search results
Results From The WOW.Com Content Network
A binary-to-text encoding is encoding of data in plain text. More precisely, it is an encoding of binary data in a sequence of printable characters. These encodings are necessary for transmission of data when the communication channel does not allow binary data (such as email or NNTP) or is not 8-bit clean. PGP documentation (RFC 4880) uses the ...
Bacon's cipher or the Baconian cipher is a method of steganographic message encoding devised by Francis Bacon in 1605. [1][2][3] In steganograhy, a message is concealed in the presentation of text, rather than its content. Baconian ciphers are categorized as both a substitution cipher (in plain code) and a concealment cipher (using the two ...
In base 2, 10110 (22 in decimal) has been proven to be a Lychrel number, since after 4 steps it reaches 10110100, after 8 steps it reaches 1011101000, after 12 steps it reaches 101111010000, and in general after 4n steps it reaches a number consisting of 10, followed by n + 1 ones, followed by 01, followed by n + 1 zeros. This number obviously ...
yEnc is a binary-to-text encoding scheme for transferring binary files in messages on Usenet or via e-mail.It reduces the overhead over previous US-ASCII-based encoding methods by using an 8-bit encoding method. yEnc's overhead is often (if each byte value appears approximately with the same frequency on average) as little as 1–2%, [1] compared to 33–40% overhead for 6-bit encoding methods ...
Sign extension (sometimes abbreviated as sext, particularly in mnemonics) is the operation, in computer arithmetic, of increasing the number of bits of a binary number while preserving the number's sign (positive/negative) and value. This is done by appending digits to the most significant side of the number, following a procedure dependent on ...
This category lists various binary-to-text encoding formats and standards.
Base64. In computer programming, Base64 is a group of binary-to-text encoding schemes that transforms binary data into a sequence of printable characters, limited to a set of 64 unique characters. More specifically, the source binary data is taken 6 bits at a time, then this group of 6 bits is mapped to one of 64 unique characters.
The binary-reflected Gray code list for n bits can be generated recursively from the list for n − 1 bits by reflecting the list (i.e. listing the entries in reverse order), prefixing the entries in the original list with a binary 0, prefixing the entries in the reflected list with a binary 1, and then concatenating the original list with the ...