Search results
Results From The WOW.Com Content Network
A two-pin version, known to the telecom industry as a "310 connector", consists of two 1 ⁄ 4-inch phone plugs at a centre spacing of 5 ⁄ 8 inch (16 mm). The socket versions of these can be used with normal phone plugs provided the plug bodies are not too large, but the plug version will only mate with two sockets at 5 ⁄ 8 inches centre ...
This includes the original 6.35 mm (quarter inch) jack and the more recent 3.5 mm (miniature or 1/8 inch) and 2.5 mm (subminiature) jacks, both mono and stereo versions. There also exists 4.4 mm Pentaconn connectors .
All NEMA 1 devices are two-wire non-grounding devices (hot-neutral) rated for 125 V maximum. 1-15P plugs have two parallel flat blades, 1 ⁄ 4 inch (6.4 mm) wide, 0.06 inches (1.5 mm) thick, 5 ⁄ 8 – 23 ⁄ 32 inch (15.9–18.3 mm) long, and spaced 1 ⁄ 2 inch (12.7 mm) apart. 1-15R receptacles have been prohibited in new construction in ...
SwitchCraft 2501F/2501M. This is the part number for a Swichcraft connector used with high impedance microphones up through about 1980. It was intended for coax style cable up to 0.281 inches (7.1 mm) outside diameter. Attachment is made with a 5/8-27 threaded ring that can be unthreaded over the body of the connector body allowing the female ...
Typically 0–100 MHz. The RCA connector[ 3] is a type of electrical connector commonly used to carry audio and video signals. The name RCA derives from the company Radio Corporation of America, which introduced the design in the 1930s. [ 4] The connector’s male plug and female jack are called RCA plug and RCA jack .
In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...
After the two common 5.5 mm OD (Outer Diameter) plugs, the next-most common size is 3.5 mm OD with a 1.3 mm ID (Inner Diameter), usually about 9.5 mm in length, although both longer and shorter versions also exist. These 3.5 mm OD plugs are normally used for lower voltages and currents.
For example, a 1 ⁄ 4-inch to 3 ⁄ 8-inch adapter allows sockets with 1 ⁄ 4-inch drive holes to attach to a 3 ⁄ 8-inch ratchet, and so on. Universal joints are two articulated socket joints (about 1 inch (25 mm) long) combined at a right angle, that allow a bend in the turning axis of the wrench and socket. They are used with extensions ...