Search results
Results From The WOW.Com Content Network
Noise temperature (antenna) In radio frequency (RF) applications such as radio, radar and telecommunications, noise temperature of an antenna is a measure of the noise power density contributed by the antenna to the overall RF receiver system. It is defined as "the temperature of a resistor having an available thermal noise power per unit ...
Antenna gain-to-noise-temperature ( G/T) is a figure of merit in the characterization of antenna performance, where G is the antenna gain in decibels at the receive frequency, and T is the equivalent noise temperature of the receiving system in kelvins. The receiving system noise temperature is the summation of the antenna noise temperature and ...
A low-noise block downconverter ( LNB) is the receiving device mounted on satellite dishes used for satellite TV reception, which collects the radio waves from the dish and converts them to a signal which is sent through a cable to the receiver inside the building. Also called a low-noise block, [ 1][ 2] low-noise converter ( LNC ), or even low ...
Ku band. Ka band. v. t. e. DVB-T2 is an abbreviation for " Digital Video Broadcasting – Second Generation Terrestrial "; it is the extension of the television standard DVB-T, issued by the consortium DVB, devised for the broadcast transmission of digital terrestrial television. DVB has been standardized by ETSI .
Full break-in or QSK operation, [ 1][ 2][ 3] is a hardware supported Morse code communications channel turn over communications protocol. So, full break-in is also a duplexing protocol, which facilitates a style of two-way Morse code communications on traditional half-duplex radiotelegraph channels that closely simulates full-duplex channel ...
A line-replaceable unit ( LRU[ 1] ), lower line-replaceable unit ( LLRU ), [citation needed] line-replaceable component ( LRC ), or line-replaceable item ( LRI) [ 2] is a modular component of an airplane, [ 3] ship or spacecraft [ 4] (or any other manufactured device) that is designed to be replaced quickly at an operating location (1st line).
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...
In telecommunications, [ 1] particularly in radio frequency engineering, signal strength refers to the transmitter power output as received by a reference antenna at a distance from the transmitting antenna. High-powered transmissions, such as those used in broadcasting, are expressed in dB - millivolts per metre (dBmV/m).