Search results
Results From The WOW.Com Content Network
A binary code represents text, computer processor instructions, or any other data using a two-symbol system. The two-symbol system used is often "0" and "1" from the binary number system. The binary code assigns a pattern of binary digits, also known as bits, to each character, instruction, etc. For example, a binary string of eight bits (which ...
A binary number is a number expressed in the base -2 numeral system or binary numeral system, a method for representing numbers that uses only two symbols for the natural numbers: typically "0" ( zero) and "1" ( one ). A binary number may also refer to a rational number that has a finite representation in the binary numeral system, that is, the ...
10001 is the binary, not decimal, representation of the desired result, but the most significant 1 (the "carry") cannot fit in a 4-bit binary number. In BCD as in decimal, there cannot exist a value greater than 9 (1001) per digit. To correct this, 6 (0110) is added to the total, and then the result is treated as two nibbles:
The Hebrew numeric system operates on the additive principle in which the numeric values of the letters are added together to form the total. For example, 177 is represented as קעז which (from right to left) corresponds to 100 + 70 + 7 = 177. Mathematically, this type of system requires 27 letters (1-9, 10–90, 100–900).
This is a list of some binary codes that are (or have been) used to represent text as a sequence of binary digits "0" and "1". Fixed-width binary codes use a set number of bits to represent each character in the text, while in variable-width binary codes, the number of bits may vary from character to character.
Braille ASCII. Braille ASCII (or more formally The North American Braille ASCII Code, also known as SimBraille) is a subset of the ASCII character set which uses 64 of the printable ASCII characters to represent all possible dot combinations in six-dot braille. It was developed around 1969 and, despite originally being known as North American ...
The atree or Binary Ahnentafel method is based on the same numbering of nodes, but first converts the numbers to binary notation and then converts each 0 to M (for Male) and each 1 to F (for Female). The first character of each code (shown as X in the table below) is M if the subject is male and F if the subject is female.
A translator using static binary translation aims to convert all of the code of an executable file into code that runs on the target architecture without having to run the code first, as is done in dynamic binary translation. This is very difficult to do correctly, since not all the code can be discovered by the translator.