Search results
Results From The WOW.Com Content Network
PIC (usually pronounced as /pɪk/) is a family of microcontrollers made by Microchip Technology, derived from the PIC1640 [ 1][ 2] originally developed by General Instrument 's Microelectronics Division. The name PIC initially referred to Peripheral Interface Controller, [ 3] and is currently expanded as Programmable Intelligent Computer. [ 4]
2.3 Service 03 - Show stored Diagnostic Trouble Codes (DTCs) 2.4 Service 04 - Clear Diagnostic Trouble Codes and stored values 2.5 Service 05 - Test results, oxygen sensor monitoring (non CAN only)
8. 19. 2. 2010. VM2 is a family of single board microcontrollers intended for use in Automation, Instrumentation, Hand Held Devices and Process Control. Programming environment: Venom2 Archived 2017-11-15 at the Wayback Machine language, VenomIDE Archived 2017-11-15 at the Wayback Machine development system, Visual Designer.
The silicon bandgap temperature sensor is an extremely common form of temperature sensor ( thermometer) used in electronic equipment. Its main advantage is that it can be included in a silicon integrated circuit at very low cost. The principle of the sensor is that the forward voltage of a silicon diode, which may be the base-emitter junction ...
Mass flow sensor. A mass (air) flow sensor ( MAF) is a sensor used to determine the mass flow rate of air entering a fuel-injected internal combustion engine . The air mass information is necessary for the engine control unit (ECU) to balance and deliver the correct fuel mass to the engine. Air changes its density with temperature and pressure.
Proportional–integral–derivative controller. A proportional–integral–derivative controller ( PID controller or three-term controller) is a control loop mechanism employing feedback that is widely used in industrial control systems and a variety of other applications requiring continuously modulated control.
Ordinary valves can have many ports and fluid paths. A 2-way valve, for example, has 2 ports; if the valve is open, then the two ports are connected and fluid may flow between the ports; if the valve is closed, then ports are isolated. If the valve is open when the solenoid is not energized, then the valve is termed normally open (N.O.).
The most common final control element in the process control industries is the control valve. The control valve manipulates a flowing fluid, such as gas, steam, water, or chemical compounds, to compensate for the load disturbance and keep the regulated process variable as close as possible to the desired set point. [ 1]