Search results
Results From The WOW.Com Content Network
Alt code. On personal computers with numeric keypads that use Microsoft operating systems, such as Windows, many characters that do not have a dedicated key combination on the keyboard may nevertheless be entered using the Alt code (the Alt numpad input method ). This is done by pressing and holding the Alt key, then typing a number on the ...
This page lists codes for keyboard characters, the computer code values for common characters, such as the Unicode or HTML entity codes (see below: Table of HTML values"). There are also key chord combinations, such as keying an en dash ('–') by holding ALT+0150 on the numeric keypad of MS Windows computers. The HTML codes can be used where a ...
ASCII ( / ˈæskiː / ⓘ ASS-kee ), [3] : 6 an acronym for American Standard Code for Information Interchange, is a character encoding standard for electronic communication. ASCII codes represent text in computers, telecommunications equipment, and other devices.
The Unicode logo. Unicode input is the insertion of a specific Unicode character on a computer by a user; it is a common way to input characters not directly supported by a physical keyboard. Unicode characters can be produced either by selecting them from a display or by typing a certain sequence of keys on a physical keyboard.
To use alt key codes for keyboard shortcut symbols you’ll need to have this enabled. If you’re using a laptop, your number pad is probably integrated to save space. No problem! Just hit the Fn ...
Value. To demonstrate the value of the escape sequence feature, to output the text Foo on one line and Bar on the next line, the code must output a newline between the two words. The following code achieves the goal via text formatting and a hard-coded ASCII character value for newline (0x0A). This behaves as desired with the words on ...
The most commonly encountered are the "XT" ("set 1") scancodes, based on the 83-key keyboard used by the IBM PC XT and earlier. These mostly consist of a single byte; the low 7 bits identify the key, and the most significant bit is clear for a key press or set for a key release. Some additional keys have an E0 (or rarely, E1 or E2) prefix.
1 Control-C has typically been used as a "break" or "interrupt" key. 2 Control-D has been used to signal "end of file" for text typed in at the terminal on Unix / Linux systems. Windows, DOS, and older minicomputers used Control-Z for this purpose. 3 Control-G is an artifact of the days when teletypes were in use.