Search results
Results From The WOW.Com Content Network
The High Pressure Coolant Injection (HPCI) System consists of a pump or pumps that have sufficient pressure to inject coolant into the reactor vessel while it is pressurized. It is designed to monitor the level of coolant in the reactor vessel and automatically inject coolant when the level drops below a threshold.
In a reciprocating engine, the cylinder is the space in which a piston travels. [1]The inner surface of the cylinder is formed from either a thin metallic liner (also called "sleeve") or a surface coating applied to the engine block.
Carnot engine diagram (modern) - where an amount of heat Q H flows from a high temperature T H furnace through the fluid of the "working body" (working substance) and the remaining heat Q C flows into the cold sink T C, thus forcing the working substance to do mechanical work W on the surroundings, via cycles of contractions and expansions.
Because the thermocouple is calibrated for room temperature, the gauge readings will only be 100% accurate at that engine compartment temperature. If the engine compartment temperature is colder, the CHT temperature will display higher. If the engine compartment temperature is higher, the reading will be lower.
Refrigeration power and efficiency are low but Peltier coolers can be small, for small cooling loads resulting in overall low power consumption for a Peltier cooler with three stages. [9] [10] [11] For a Peltier cooler with seven stages, power consumption can be 65 W with a cooling capacity of 80 mW. [12]
The Stirling engine uses the temperature difference between its hot end and cold end to establish a cycle of a fixed mass of gas, heated and expanded, and cooled and compressed, thus converting thermal energy into mechanical energy. The greater the temperature difference between the hot and cold sources, the greater the thermal efficiency.
Isothermal transformation diagrams (also known as time-temperature-transformation (TTT) diagrams) are plots of temperature versus time (usually on a logarithmic scale). They are generated from percentage transformation-vs time measurements, and are useful for understanding the transformations of an alloy steel at elevated temperatures.
The Roman hypocaust is an early example of a type of radiator for building space heating. Franz San Galli, a Prussian-born Russian businessman living in St. Petersburg, is credited with inventing the heating radiator around 1855, [1] [2] having received a radiator patent in 1857, [3] but American Joseph Nason developed a primitive radiator in 1841 [4] and received a number of U.S. patents for ...