Search results
Results From The WOW.Com Content Network
1.0 imp qt (1,100 ml; 38 US fl oz) imperial pint: imppt imp pt 1/8 imp gal or 20 imp fl oz 1.0 imp pt (0.57 L) imperial fluid ounce: impoz (impfloz) imp fl oz 1/160 imp gal 1.0 imp fl oz (28 ml; 0.96 US fl oz) impoz USoz; impoz U.S.oz; impoz ml; impoz mL; US customary liquid measure: US barrel: USbbl US bbl 31½ US gal
The US fluid ounce is based on the US gallon, which in turn is based on the wine gallon of 231 cubic inches that was used in the United Kingdom prior to 1824. With the adoption of the international inch, the US fluid ounce became 1⁄128 gal × 231 in 3 /gal × (2.54 cm/in) 3 = 29.5735295625 mL exactly, or about 4% larger than the imperial unit.
t. e. Reference ranges (reference intervals) for blood tests are sets of values used by a health professional to interpret a set of medical test results from blood samples. Reference ranges for blood tests are studied within the field of clinical chemistry (also known as "clinical biochemistry", "chemical pathology" or "pure blood chemistry ...
For example, sulfuric acid (H 2 SO 4) is a diprotic acid. Since only 0.5 mol of H 2 SO 4 are needed to neutralize 1 mol of OH −, the equivalence factor is: feq (H 2 SO 4) = 0.5. If the concentration of a sulfuric acid solution is c (H 2 SO 4) = 1 mol/L, then its normality is 2 N. It can also be called a "2 normal" solution.
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m ). [ 13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd ...
The general relationship between absorbed dose and equivalent dose can be represented as. H = Q ⋅ D. where H is the equivalent dose, D is the absorbed dose, and Q is a dimensionless quality factor. Thus, for any quantity of D measured in Gy, the numerical value for H measured in Sv may be different.
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
The actual amount of glucose in the blood and body fluids is very small. In a healthy adult male of 75 kg (165 lb) with a blood volume of 5 L, a blood glucose level of 5.5 mmol/L (100 mg/dL) amounts to 5 g, equivalent to about a teaspoonful of sugar. [ 13]