Search results
Results From The WOW.Com Content Network
Static routing is a form of routing that occurs when a router uses a manually-configured routing entry, rather than information from dynamic routing traffic. [ 1] In many cases, static routes are manually configured by a network administrator by adding in entries into a routing table, though this may not always be the case. [ 2]
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
The T-carrier is a hardware specification for carrying multiple time-division multiplexed (TDM) telecommunications channels over a single four-wire transmission circuit. It was developed by AT&T at Bell Laboratories ca. 1957 and first employed by 1962 for long-haul pulse-code modulation (PCM) digital voice transmission with the D1 channel bank .
IP routing. IP routing is the application of routing methodologies to IP networks. This involves not only protocols and technologies but includes the policies of the worldwide organization and configuration of Internet infrastructure. In each IP network node, IP routing involves the determination of a suitable path for a network packet from a ...
The WPS push button (center, blue) on a wireless router showing the symbol defined by the Wi-Fi Alliance for this function. Wi-Fi Protected Setup ( WPS) originally, Wi-Fi Simple Config, is a network security standard to create a secure wireless home network . Created by Cisco and introduced in 2006, the purpose of the protocol is to allow home ...
Administrative distance ( AD) or route preference[ 1] is a number of arbitrary unit assigned to dynamic routes, static routes and directly-connected routes. The value is used in routers to rank routes from most preferred (low AD value) to least preferred (high AD value). [ 2][ 3] When multiple paths to the same destination are available in its ...
In network routing, the control plane is the part of the router architecture that is concerned with establishing the network topology, or the information in a routing table that defines what to do with incoming packets. Control plane functions, such as participating in routing protocols, run in the architectural control element. [ 1]
Policy-based routing. In computer networking, policy-based routing ( PBR) is a technique used to make routing decisions based on policies set by the network administrator. When a router receives a packet it normally decides where to forward it based on the destination address in the packet, which is then used to look up an entry in a routing table.