Search results
Results From The WOW.Com Content Network
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
Geographic coordinate conversion has applications in cartography, surveying, navigation and geographic information systems . In geodesy, geographic coordinate conversion is defined as translation among different coordinate formats or map projections all referenced to the same geodetic datum. [ 1] A geographic coordinate transformation is a ...
For petroleum gases, the standard cubic foot (scf) is defined as one cubic foot of gas at 60 °F (288.7 K; 15.56 °C) and at normal sea level air pressure. The pressure definition differs between sources, but are all close to normal sea level air pressure. A pressure of 14.696 pounds per square inch (1.00000 atm; 101.325 kPa ). [ 2]
The general relationship between absorbed dose and equivalent dose can be represented as. H = Q ⋅ D. where H is the equivalent dose, D is the absorbed dose, and Q is a dimensionless quality factor. Thus, for any quantity of D measured in Gy, the numerical value for H measured in Sv may be different.
In radar -related subjects and in JTIDS, a data mile is a unit of distance equal to 6000 feet (1.8288 kilometres or 0.987 nautical miles ). An international mile is exactly 0.88 of a data mile. The speed of light is 983571056 ft/s, or about one foot per nanosecond. If it were exactly one foot per nanosecond, and a target was one data mile away ...
A geoid is needed to convert the 3D position to sea-level elevation. Pressure altimeter measuring atmospheric pressure, which decreases as altitude increases. Since atmospheric pressure varies with the weather, too, a recent local measure of the pressure at a known altitude is needed to calibrate the altimeter. Stereoscopy in aerial photography.
Standard cubic feet per minute ( SCFM) is the molar flow rate of a gas expressed as a volumetric flow at a "standardized" temperature and pressure thus representing a fixed number of moles of gas regardless of composition and actual flow conditions. It is related to the mass flow rate of the gas by a multiplicative constant which depends only ...