Search results
Results From The WOW.Com Content Network
Braille ASCII. Braille ASCII (or more formally The North American Braille ASCII Code, also known as SimBraille) is a subset of the ASCII character set which uses 64 of the printable ASCII characters to represent all possible dot combinations in six-dot braille. It was developed around 1969 and, despite originally being known as North American ...
v. t. e. In mathematics and computing, the hexadecimal (also base-16 or simply hex) numeral system is a positional numeral system that represents numbers using a radix (base) of sixteen. Unlike the decimal system representing numbers using ten symbols, hexadecimal uses sixteen distinct symbols, most often the symbols "0"–"9" to represent ...
Chart of the Morse code 26 letters and 10 numerals [1]. This Morse key was originally used by Gotthard railway, later by a shortwave radio amateur [2]. Morse code is a telecommunications method which encodes text characters as standardized sequences of two different signal durations, called dots and dashes, or dits and dahs.
A binary coderepresents text, computer processor instructions, or any other datausing a two-symbol system. The two-symbol system used is often "0" and "1" from the binary number system. The binary code assigns a pattern of binary digits, also known as bits, to each character, instruction, etc. For example, a binary stringof eight bits (which is ...
Braille ( / breɪl / BRAYL, French: [bʁɑj]) is a tactile writing system used by people who are visually impaired. It can be read either on embossed paper or by using refreshable braille displays that connect to computers and smartphone devices. Braille can be written using a slate and stylus, a braille writer, an electronic braille notetaker ...
This is a list of some binary codes that are (or have been) used to represent text as a sequence of binary digits "0" and "1". Fixed-width binary codes use a set number of bits to represent each character in the text, while in variable-width binary codes, the number of bits may vary from character to character.
The atree or Binary Ahnentafel method is based on the same numbering of nodes, but first converts the numbers to binary notation and then converts each 0 to M (for Male) and each 1 to F (for Female). The first character of each code (shown as X in the table below) is M if the subject is male and F if the subject is female.
Base32 is an encoding method based on the base-32 numeral system.It uses an alphabet of 32 digits, each of which represents a different combination of 5 bits (2 5).Since base32 is not very widely adopted, the question of notation—which characters to use to represent the 32 digits—is not as settled as in the case of more well-known numeral systems (such as hexadecimal), though RFCs and ...