Search results
Results From The WOW.Com Content Network
The load index on a passenger-car tire is a numerical code stipulating the maximum load (mass, or weight) each tire can carry. For load range "B" tires, ETRTO (ISO-Metric) standards specify the load index rating at an inflation pressure of 36 psi (250 kPa) (table below), while P-Metric standards measure the load capacity at an inflation ...
The visible outer thread of the stem holds the dust cap. The Schrader valve (also called American valve[ 1]) is a type of pneumatic tire valve used on virtually every motor vehicle in the world today. The Schrader company, for which it was named, was founded in 1844 by August Schrader. The original Schrader valve design was invented in 1891 ...
UTQG ratings (top) and tire code (bottom) on sidewall of Continental ContiProContact tire. Uniform Tire Quality Grading, commonly abbreviated as UTQG, is a set of standards for passenger car tires that measures a tire's treadwear, temperature resistance and traction. The UTQG was created by the National Highway Traffic Safety Administration in ...
Temperature: with both solid and pneumatic tires, rolling resistance has been found to decrease as temperature increases (within a range of temperatures: i.e. there is an upper limit to this effect) [59] [60] For a rise in temperature from 30 °C to 70 °C the rolling resistance decreased by 20-25%. [61]
As the early motorcycle industry progressed, larger tyre sizes accompanied larger engine displacements, so that by 1909–1914, 2 + 1 ⁄ 4 in (57 mm) section, 26 in (660 mm) diameter tyres were used on 250 to 350 cc (15 to 21 cu in) motorcycles, and 2 + 3 ⁄ 8 to 2 + 1 ⁄ 2 in (60 to 64 mm) section tyres appeared on motorcycles with ...
With power typically being the product of force and speed, a motorcycle's power and torque ratings will be highly indicative of its performance. Reported numbers for power and torque may however vary from one source to another due to inconsistencies in how testing equipment is calibrated, the method of using that equipment, the conditions during the test, and particularly the location that ...
Cold inflation pressure is the inflation pressure of tires before a car is driven and the tires (tyres) warmed up. Recommended cold inflation pressure is displayed on the owner's manual and on the placard (or sticker) attached to the vehicle door edge, pillar, glovebox door or fuel filler flap. Most passenger cars are recommended to have a tire ...
Contact patch. The contact patch is the portion of a vehicle's tire that is in actual contact with the road surface. It is commonly used in the discussion of pneumatic (i.e. pressurized) tires, where the term is used strictly to describe the portion of the tire’s tread that touches the road surface. The term “footprint” is used almost ...