Search results
Results From The WOW.Com Content Network
Fast Ethernet is an extension of the 10-megabit Ethernet standard. It runs on twisted pair or optical fiber cable in a star wired bus topology, similar to the IEEE standard 802.3i called 10BASE-T, itself an evolution of 10BASE5 (802.3) and 10BASE2 (802.3a). Fast Ethernet devices are generally backward compatible with existing 10BASE-T systems ...
Network delay is a design and performance characteristic of a telecommunications network. It specifies the latency for a bit of data to travel across the network from one communication endpoint to another. [ 1][ 2]: 5 It is typically measured in multiples or fractions of a second. Delay may differ slightly, depending on the location of the ...
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
Type of service. The type of service ( ToS) field is the second byte of the IPv4 header. It has had various purposes over the years, and has been defined in different ways by five RFCs. [ 1] Prior to the redefinition, the ToS field could specify a datagram's priority and request a route for low-latency, high-throughput, or highly-reliable service.
Classless Inter-Domain Routing ( CIDR / ˈsaɪdər, ˈsɪ -/) is a method for allocating IP addresses for IP routing. The Internet Engineering Task Force introduced CIDR in 1993 to replace the previous classful network addressing architecture on the Internet. Its goal was to slow the growth of routing tables on routers across the Internet, and ...
It is typically measured at a reference point below the network layer and above the physical layer. The simplest definition is the number of bits per second that are physically delivered. A typical example where this definition is practiced is an Ethernet network. In this case, the maximum throughput is the gross bit rate or raw bit rate.
The defining expression for entropy in the theory of information established by Claude E. Shannon in 1948 is of the form: where is the probability of the message taken from the message space M, and b is the base of the logarithm used. Common values of b are 2, Euler's number e, and 10, and the unit of entropy is shannon (or bit) for b = 2, nat ...
Transmission time. In telecommunication networks, the transmission time is the amount of time from the beginning until the end of a message transmission. In the case of a digital message, it is the time from the first bit until the last bit of a message has left the transmitting node. The packet transmission time in seconds can be obtained from ...