Search results
Results From The WOW.Com Content Network
The left and right channels are produced through a simple matrix: Left = Mid + Side; Right = Mid − Side (the polarity-reversed side signal). This configuration produces a completely mono-compatible signal and, if the Mid and Side signals are recorded (rather than the matrixed Left and Right), the stereo width can be manipulated after the ...
The original audio signal was left alone and broadcast as it always had been. Under MTS, this is the Main Channel. The actual signal in this channel is constructed by adding together the two stereo channels to produce a signal largely identical to the original monoaural signals and can be received on any NTSC television even without stereo ...
Panning is the distribution of an audio signal (either monaural or stereophonic pairs) into a new stereo or multi-channel sound field determined by a pan control setting. A typical physical recording console has a pan control for each incoming source channel. A pan control or pan pot (short for "panning potentiometer") is an analog control with ...
Converting the multiplex signal back into left and right audio signals is performed by a decoder, built into stereo receivers. Again, the decoder can use a switching technique to recover the left and right channels. In addition, for a given RF level at the receiver, the signal-to-noise ratio and multipath distortion for the stereo signal will ...
Sound localization is a listener's ability to identify the location or origin of a detected sound in direction and distance. The sound localization mechanisms of the mammalian auditory system have been extensively studied. The auditory system uses several cues for sound source localization, including time difference and level difference (or ...
Two phase-shifted sinusoid inputs are applied to the oscilloscope in X-Y mode and the phase relationship between the signals is presented as a Lissajous figure. In the professional audio world, this method is used for realtime analysis of the phase relationship between the left and right channels of a stereo audio signal.
The optical soundtrack on a Dolby Stereo encoded 35 mm film carries not only left and right tracks for stereophonic sound, but also—through a matrix decoding system (Dolby Motion Picture matrix or Dolby MP [4]) similar to that developed for "quadraphonic" or "quad" sound in the 1970s—a third center channel, and a fourth surround channel for ...
The function of the center channel can either be of a monophonic nature (as with dialogue) or it can be used in combination with the left and right channels for true three-channel stereo. Motion Pictures tend to use the center channel for monophonic purposes with stereo being reserved purely for the left and right channels.