Search results
Results From The WOW.Com Content Network
Insulation system. The electrical insulation system for wires used in generators, electric motors, transformers, and other wire-wound electrical components is divided into different classes by temperature and temperature rise. The electrical insulation system is sometimes referred to as insulation class or thermal classification.
IEC 60269 unifies the electrical characteristics of fuses that are dimensionally interchangeable with fuses built to earlier British, German, French or Italian standards. [ 2] The standard identifies application categories which classify the time-current characteristic of each type of fuse. The application category is a two-digit code.
The design target was a 2300F (1260C) rotor inlet temperature, with a mature rating expected to be around 160 MW. The introductory rating was set at 145 MW with simple cycle heat rate of 10,000 Btu/kwh or 34% efficiency. The combined cycle efficiency being advertised at the time was "better than 50%".
Thermodynamic pump testing is a form of pump testing where only the temperature rise, power consumed, and differential pressure need to be measured to find the efficiency of a pump. These measurements are typically made with insertion temperature probes and pressure probes fitted to tapping points on the pump's inlet and outlet. [1]
Operating temperature. An operating temperature is the allowable temperature range of the local ambient environment at which an electrical or mechanical device operates. The device will operate effectively within a specified temperature range which varies based on the device function and application context, and ranges from the minimum ...
IEC TR 60943 Guidance concerning the permissible temperature rise for parts of electrical equipment, in particular for terminals; IEC 60944 Guide for the maintenance of silicone transformer liquids; IEC 60945 Maritime navigation and radiocommunication equipment and systems – General requirements – Methods of testing and required test results
For example, a conventional heat pump system used to heat a building in Montana's −57 °C (−70 °F) low temperature or cool a building in the highest temperature ever recorded in the US—57 °C (134 °F) in Death Valley, California, in 1913 would require a large amount of energy due to the extreme difference between inside and outside air ...
This rating does not apply to all generator set models. Typical application - where the generator is the sole source of power for say a remote mining or construction site, fairground, festival etc. Base Load (Continuous) Rating based on: Applicable for supplying power continuously to a constant load up to the full output rating for unlimited ...