Ad
related to: temperature code t4 meaning on tv antenna cable connector parts
Search results
Results From The WOW.Com Content Network
A TV aerial plug is a connector used to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal amplifiers, CATV distribution equipment, TV sets and FM / DAB-radio receivers. In Europe and Australia the Belling-Lee connector (IEC 61169-2 radio-frequency coaxial connector of type 9,52) is commonly used ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...
The antenna is connected to the television with a specialized cable designed to carry radio current, called transmission line. Earlier antennas used a flat cable called 300 ohm twin-lead . The standard today is 75 ohm coaxial cable , which is less susceptible to interference which plugs into an F connector or Belling-Lee connector (depending on ...
SR connector (from Russian: Cоединитель Pадиочастотный) is a Russian RF connector, based on the BNC connector and which comes in a 50 Ω and 75 Ω versions. TNC connector (threaded Neill-Concelman) Twin-BNC (Twinax) Twinax connectors are used with 78 Ω or 95 Ω conductor cables and operate from 0–200 MHz.
The F connector (also F-type connector) is a coaxial RF connector commonly used for "over the air" terrestrial television, cable television and universally for satellite television and cable modems, usually with RG-6/U cable or with RG-59/U cable . The F connector was invented by Eric E. Winston in the early 1950s while working for Jerrold ...
A low-noise block downconverter ( LNB) is the receiving device mounted on satellite dishes used for satellite TV reception, which collects the radio waves from the dish and converts them to a signal which is sent through a cable to the receiver inside the building. Also called a low-noise block, [ 1][ 2] low-noise converter ( LNC ), or even low ...
An RF connector ( radio frequency connector) is an electrical connector designed to work at radio frequencies in the multi-megahertz range. RF connectors are typically used with coaxial cables and are designed to maintain the shielding that the coaxial design offers. Better models also minimize the change in transmission line impedance at the ...
Time domain reflectometry is used in semiconductor failure analysis as a non-destructive method for the location of defects in semiconductor device packages. The TDR provides an electrical signature of individual conductive traces in the device package, and is useful for determining the location of opens and shorts.
Ad
related to: temperature code t4 meaning on tv antenna cable connector parts