Search results
Results From The WOW.Com Content Network
The Bluetooth protocol RFCOMM is a simple set of transport protocols, made on top of the L2CAP protocol, providing emulated RS-232 serial ports (up to sixty simultaneous connections to a Bluetooth device at a time). The protocol is based on the ETSI standard TS 07.10. RFCOMM is sometimes called serial port emulation.
Identification, friend or foe ( IFF) is a combat identification system designed for command and control. It uses a transponder that listens for an interrogation signal and then sends a response that identifies the broadcaster. IFF systems usually use radar frequencies, but other electromagnetic frequencies, radio or infrared, may be used. [1]
The aviation transponder interrogation modes are the standard formats of pulsed sequences from an interrogating Secondary Surveillance Radar (SSR) or similar Automatic Dependent Surveillance-Broadcast (ADS-B) system. The reply format is usually referred to as a "code" from a transponder, which is used to determine detailed information from a ...
Amateur teleprinting over radio (AMTOR) D-STAR (Digital Data) a high speed (128 kbit/s), data-only mode. Hellschreiber, also referred to as either Feld-Hell, or Hell a facsimile-based teleprinter. Discrete multi-tone modulation modes such as Multi Tone 63 (MT63) Multiple frequency-shift keying (MFSK) modes such as. FSK441, JT6M, JT65, and FT8.
Run-length limited. Run-length limited or RLL coding is a line coding technique that is used to send arbitrary data over a communications channel with bandwidth limits. RLL codes are defined by four main parameters: m, n, d, k. The first two, m / n, refer to the rate of the code, while the remaining two specify the minimal d and maximal k ...
LDPC codes have no limitations of minimum distance, that indirectly means that LDPC codes may be more efficient on relatively large code rates (e.g. 3/4, 5/6, 7/8) than turbo codes. However, LDPC codes are not the complete replacement: turbo codes are the best solution at the lower code rates (e.g. 1/6, 1/3, 1/2). See also People
List of aircraft type designators. An aircraft type designator is a two-, three- or four-character alphanumeric code designating every aircraft type (and some sub-types) that may appear in flight planning. These codes are defined by both the International Civil Aviation Organization (ICAO) and the International Air Transport Association (IATA).
The code-rate is hence a real number. A low code-rate close to zero implies a strong code that uses many redundant bits to achieve a good performance, while a large code-rate close to 1 implies a weak code. The redundant bits that protect the information have to be transferred using the same communication resources that they are trying to protect.