Search results
Results From The WOW.Com Content Network
French catheter scale. The French scale, French gauge or Charrière system is commonly used to measure the size of a catheter. It is most often abbreviated as Fr, but can often be seen abbreviated as Fg, FR or F. It may also be abbreviated as CH or Ch (for Charrière, its inventor). However, simply gauge, G or GA generally refers to Birmingham ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
Metric ( SI) units. 25.4 mm. A fire hydrant marked as 3-inch. The inch (symbol: in or ″) is a unit of length in the British Imperial and the United States customary systems of measurement. It is equal to 1 36 yard or 1 12 of a foot. Derived from the Roman uncia ("twelfth"), the word inch is also sometimes used to translate ...
The actual size of the drive bays differ from their name (e.g., 3 1 ⁄ 2" drive bays are actually 4 inches (101.6 mm) wide, because 3 1 ⁄ 2" refers to the historical platter diameter inside the drive). The newer 2 1 ⁄ 2 inch and 1.8 inch drive bays are specified in
T scale, using 3 mm gauge track to represent standard gauge railways. 1:450. 0.677 mm. Model railways (T) T scale, using 3 mm gauge track to represent 3 ft 6 in ( 1,067 mm) gauge railways. Hasegawa also produces plastic ship models in this scale. 1:432.
A circular milis a unitof area, equal to the area of a circlewith a diameterof one mil(one thousandth of an inch or 0.0254 mm). It corresponds to approximately 5.067×10−4 mm2. It is a unit intended for referring to the area of a wire with a circular cross section.
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m ). [ 13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd ...
An input unit can be converted to any number of output units—the outputs are specified as a "combination" by separating unit codes with a space (" ") or a plus (" + "). Using a space as a separator does not work if any of the unit codes contains a space. For example, each of the following converts 1.2 km 2 to acres, square yards, and hectares.