Search results
Results From The WOW.Com Content Network
Logical address. In computing, a logical address is the address at which an item ( memory cell, storage element, network host) appears to reside from the perspective of an executing application program. A logical address may be different from the physical address due to the operation of an address translator or mapping function.
Physical address. In computing, a physical address (also real address, or binary address ), is a memory address that is represented in the form of a binary number on the address bus circuitry in order to enable the data bus to access a particular storage cell of main memory, or a register of memory-mapped I/O device.
In early computers logical and physical addresses corresponded, but since the introduction of virtual memory most application programs do not have a knowledge of physical addresses. Rather, they address logical addresses, or virtual addresses, using the computer's memory management unit and operating system memory mapping; see below.
Address space. In computing, an address space defines a range of discrete addresses, each of which may correspond to a network host, peripheral device, disk sector, a memory cell or other logical or physical entity. For software programs to save and retrieve stored data, each datum must have an address where it can be located.
If the paging unit is enabled, addresses in a segment are now virtual addresses, rather than physical addresses as they were on the 80286. That is, the segment starting address, the offset, and the final 32-bit address the segmentation unit derived by adding the two are all virtual (or logical) addresses when the paging unit is enabled.
Gateway address. The gateway address (or default gateway) is a router interface connected to the local network that sends packets out of the local network. The gateway has a physical and a logical address.
In logical block addressing, only one number is used to address data, and each linear base address describes a single block. The LBA scheme replaces earlier schemes which exposed the physical details of the storage device to the software of the operating system. Chief among these was the cylinder-head-sector (CHS) scheme, where blocks were addressed by means
Physical and virtual address space sizes. Paging is one way of allowing the size of the addresses used by a process, which is the process's "virtual address space" or "logical address space", to be different from the amount of main memory actually installed on a particular computer, which is the physical address space.