Search results
Results From The WOW.Com Content Network
Electronic throttle control ( ETC) is an automobile technology that uses electronics to replace the traditional mechanical linkages between the driver's input such as a foot pedal to the vehicle's throttle mechanism which regulates speed or acceleration. This concept is often called drive by wire, [ 1][ 2] and sometimes called accelerate-by ...
Digifant is an Engine Management System operated by an Engine Control Unit that actuates outputs, such as fuel injection and ignition systems, using information derived from sensor inputs, such as engine speed, exhaust oxygen and intake air flow. [ 1] Digifant was designed by Volkswagen Group, in cooperation with Robert Bosch GmbH .
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
The IAC actuator is an electrically controlled device, which gets its input from the vehicle's engine control unit (ECU). The actuator is fitted such that it either bypasses the throttle or operates the throttle butterfly valve directly. The actuator consists of a linear servo actuator servomotor that controls a plunger which varies air flow ...
Variable valve timing ( VVT) is the process of altering the timing of a valve lift event in an internal combustion engine, and is often used to improve performance, fuel economy or emissions. It is increasingly being used in combination with variable valve lift systems. There are many ways in which this can be achieved, ranging from mechanical ...
A throttle position sensor ( TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used. For example, an extra "closed throttle position ...
An engine control unit ( ECU ), also called an engine control module ( ECM ), [ 1] is a device which controls multiple systems of an internal combustion engine in a single unit. Systems commonly controlled by an ECU include the fuel injection and ignition systems. The earliest ECUs (used by aircraft engines in the late 1930s) were mechanical ...
Thermotime switch. A thermotime switch, or TTS, is a sensor used to control the cold start enrichment process in some older fuel injection systems. An extra injector is placed in the inlet manifold designed to feed all of the cylinders, and whilst the other injectors have flow rates controlled by pulse duration, the cold start injector stays on ...