Search results
Results From The WOW.Com Content Network
54. /. 5 π ≈ 3.4377′. A milliradian ( SI -symbol mrad, sometimes also abbreviated mil) is an SI derived unit for angular measurement which is defined as a thousandth of a radian (0.001 radian). Milliradians are used in adjustment of firearm sights by adjusting the angle of the sight compared to the barrel (up, down, left, or right).
MIL-STD-1474, a sound measurement for small arms standard; MIL-STD-1464A, the Army Nomenclature System used in naming weapons and other materiel, like the M16 rifle [27] MIL-STD-1553, a digital communications bus [28] MIL-STD-1589, "JOVIAL programming language" [29] MIL-STD-1661, a Navy standard for naming/designation
The Military Grid Reference System ( MGRS) [ 1] is the geocoordinate standard used by NATO militaries for locating points on Earth. The MGRS is derived from the Universal Transverse Mercator (UTM) grid system and the Universal Polar Stereographic (UPS) grid system, but uses a different labeling convention. The MGRS is used as geocode for the ...
The operational success of a "Test Shop" program set up at March AFB, California, on 15 September 1957, led to the establishment of the base-level Precision Measurement Equipment Laboratories providing the Air Force with a complete calibration system that could handle the increasingly stringent measurement needs of the new missile and aircraft ...
The official model for the military colours was established in 1911 and states that they should measure 120 cm in the hoist by 130 cm in the fly, the field being vertically divided in green and red, with the National coat of arms in the centre, surrounded by two golden olive branches tied by a white scroll containing the motto Esta é a Ditosa ...
Stadiametric rangefinding often uses the milliradian ("mil" or "mrad") as the unit of angular measurement. Since a radian is defined as the angle formed when the length of a circular arc equals the radius of the circle, a milliradian is the angle formed when the length of a circular arc equals 1/1000 of the radius of the circle.
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m ). [ 13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd ...
Horizontal pitch (HP) is a unit of length defined by the Eurocard printed circuit board standard used to measure the horizontal width of rack mounted electronic equipment, similar to the rack unit (U) used to measure vertical heights of rack mounted equipment. One HP is 0.2 inches (1/5") or 5.08 millimetres wide.