Search results
Results From The WOW.Com Content Network
A binary number may also refer to a rational number that has a finite representation in the binary numeral system, that is, the quotient of an integer by a power of two. The base-2 numeral system is a positional notation with a radix of 2. Each digit is referred to as a bit, or binary digit.
Binary code. The word 'Wikipedia' represented in ASCII binary code, made up of 9 bytes (72 bits). A binary code represents text, computer processor instructions, or any other data using a two-symbol system. The two-symbol system used is often "0" and "1" from the binary number system. The binary code assigns a pattern of binary digits, also ...
10001 is the binary, not decimal, representation of the desired result, but the most significant 1 (the "carry") cannot fit in a 4-bit binary number. In BCD as in decimal, there cannot exist a value greater than 9 (1001) per digit. To correct this, 6 (0110) is added to the total, and then the result is treated as two nibbles:
Base64. In computer programming, Base64 is a group of binary-to-text encoding schemes that transforms binary data into a sequence of printable characters, limited to a set of 64 unique characters. More specifically, the source binary data is taken 6 bits at a time, then this group of 6 bits is mapped to one of 64 unique characters.
A translator using static binary translation aims to convert all of the code of an executable file into code that runs on the target architecture without having to run the code first, as is done in dynamic binary translation. This is very difficult to do correctly, since not all the code can be discovered by the translator.
This article contains Unicode Braille characters. Without proper rendering support, you may see question marks, boxes, or other symbols instead of Braille characters. The Unicode block Braille Patterns (U+2800..U+28FF) contains all 256 possible patterns of an 8-dot braille cell, thereby including the complete 6-dot cell range. [3] In Unicode, a ...
A bitwise AND is a binary operation that takes two equal-length binary representations and performs the logical AND operation on each pair of the corresponding bits. Thus, if both bits in the compared position are 1, the bit in the resulting binary representation is 1 (1 × 1 = 1); otherwise, the result is 0 (1 × 0 = 0 and 0 × 0 = 0).
The default OperandSize and AddressSize to use for each instruction is given by the D bit of the segment descriptor of the current code segment - D=0 makes both 16-bit, D=1 makes both 32-bit. Additionally, they can be overridden on a per-instruction basis with two new instruction prefixes that were introduced in the 80386: