Gamer.Site Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Noise temperature (antenna) - Wikipedia

    en.wikipedia.org/wiki/Noise_temperature_(antenna)

    Noise temperature (antenna) In radio frequency (RF) applications such as radio, radar and telecommunications, noise temperature of an antenna is a measure of the noise power density contributed by the antenna to the overall RF receiver system. It is defined as "the temperature of a resistor having an available thermal noise power per unit ...

  3. Antenna gain-to-noise-temperature - Wikipedia

    en.wikipedia.org/wiki/Antenna_gain-to-noise...

    Antenna gain-to-noise-temperature ( G/T) is a figure of merit in the characterization of antenna performance, where G is the antenna gain in decibels at the receive frequency, and T is the equivalent noise temperature of the receiving system in kelvins. The receiving system noise temperature is the summation of the antenna noise temperature and ...

  4. Low-noise block downconverter - Wikipedia

    en.wikipedia.org/wiki/Low-noise_block_downconverter

    A low-noise block downconverter ( LNB) is the receiving device mounted on satellite dishes used for satellite TV reception, which collects the radio waves from the dish and converts them to a signal which is sent through a cable to the receiver inside the building. Also called a low-noise block, [ 1][ 2] low-noise converter ( LNC ), or even low ...

  5. DVB-T2 - Wikipedia

    en.wikipedia.org/wiki/DVB-T2

    Ku band. Ka band. v. t. e. DVB-T2 is an abbreviation for " Digital Video Broadcasting – Second Generation Terrestrial "; it is the extension of the television standard DVB-T, issued by the consortium DVB, devised for the broadcast transmission of digital terrestrial television. DVB has been standardized by ETSI .

  6. Reference designator - Wikipedia

    en.wikipedia.org/wiki/Reference_designator

    A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...

  7. QSK operation (full break-in) - Wikipedia

    en.wikipedia.org/wiki/QSK_operation_(full_break-in)

    Full break-in or QSK operation, [ 1][ 2][ 3] is a hardware supported Morse code communications channel turn over communications protocol. So, full break-in is also a duplexing protocol, which facilitates a style of two-way Morse code communications on traditional half-duplex radiotelegraph channels that closely simulates full-duplex channel ...

  8. Sutton Coldfield transmitting station - Wikipedia

    en.wikipedia.org/wiki/Sutton_Coldfield...

    Sutton Coldfield. /  52.60056°N 1.83389°W  / 52.60056; -1.83389. The Sutton Coldfield transmitting station is a broadcasting and telecommunications facility located in Sutton Coldfield, Birmingham, England. In terms of population covered, it is the third most important transmitter in the UK, after Crystal Palace in London and Winter ...

  9. Engineering drawing abbreviations and symbols - Wikipedia

    en.wikipedia.org/wiki/Engineering_drawing...

    A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing. One corporation can have many CAGE codes, as can one government, because each division, department, and site (campus) can have its own CAGE code.