Search results
Results From The WOW.Com Content Network
NFPA 704 safety squares on containers of ethyl alcohol and acetone. " NFPA 704: Standard System for the Identification of the Hazards of Materials for Emergency Response " is a standard maintained by the U.S. -based National Fire Protection Association. First "tentatively adopted as a guide" in 1960, [1] and revised several times since then, it ...
Dynamic line rating (DLR), also known as real-time thermal rating (RTTR), is an electric power transmission operation philosophy aiming at maximizing load, when environmental conditions allow it, without compromising safety. Research, prototyping and pilot projects were initiated in the 1990s, but the emergence of the "smart grid" stimulated ...
This rating is the requirement in data safes and vault structures for protecting digital information on magnetic media or hard drives. Temperatures inside the protected chamber must be held below 125 °F (52 °C) for the time period specified, such as Class 125-2 Hour, with temperatures up to 2,000 °F (1,090 °C) outside the vault.
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
An operating temperature is the allowable temperature range of the local ambient environment at which an electrical or mechanical device operates. The device will operate effectively within a specified temperature range which varies based on the device function and application context, and ranges from the minimum operating temperature to the maximum operating temperature (or peak operating ...
The DOT code [1] is an alphanumeric character sequence molded into the sidewall of the tire and allows the identification of the tire and its age. The code is mandated by the U.S. Department of Transportation [2] but is used worldwide. [3] The DOT code is also useful in identifying tires subject to product recall [4] or at end of life due to age.
An arc flash is the light and heat produced as part of an arc fault (sometimes referred to as an electrical flashover), a type of electrical explosion or discharge that results from a connection through air to ground or another voltage phase in an electrical system. Arc flash is distinctly different from the arc blast, which is the supersonic ...
R. -value (insulation) The R-value (in K ⋅ m 2/ W) is a measure of how well a two-dimensional barrier, such as a layer of insulation, a window or a complete wall or ceiling, resists the conductive [2] flow of heat, in the context of construction. [3] R-value is the temperature difference per unit of heat flux needed to sustain one unit of ...