Search results
Results From The WOW.Com Content Network
The Lead and Copper Rule ( LCR) is a United States federal regulation that limits the concentration of lead and copper allowed in public drinking water at the consumer's tap, as well as limiting the permissible amount of pipe corrosion occurring due to the water itself. [1] The U.S. Environmental Protection Agency (EPA) first issued the rule in ...
Detection limit. The limit of detection ( LOD or LoD) is the lowest signal, or the lowest corresponding quantity to be determined (or extracted) from the signal, that can be observed with a sufficient degree of confidence or statistical significance. However, the exact threshold (level of decision) used to decide when a signal significantly ...
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
When the magnetic field is removed, the contacts in the reed switch return to their original position. The "reed" is the metal part inside the reed switch envelope that is relatively thin and wide to make it flexible, resembling the reed of a musical instrument. The term "reed" may also include the external wire lead as well as the internal part.
Time-domain reflectometer for cable fault detection. A time-domain reflectometer ( TDR) is an electronic instrument used to determine the characteristics of electrical lines by observing reflected pulses . It can be used to characterize and locate faults in metallic cables (for example, twisted pair wire or coaxial cable ), [1] and to locate ...
The thermocouple line consists of copper wire, insulator and outer metal (usually copper) sheath which is also used as ground. [30] Many gas-fed heating appliances such as ovens and water heaters make use of a pilot flame to ignite the main gas burner when required. If the pilot flame goes out, unburned gas may be released, which is an ...
Capacitive sensing. In electrical engineering, capacitive sensing (sometimes capacitance sensing) is a technology, based on capacitive coupling, that can detect and measure anything that is conductive or has a dielectric constant different from air. Many types of sensors use capacitive sensing, including sensors to detect and measure proximity ...
Temperature effects on the lead wires can be cancelled by using a "3-wire bridge" or a "4-wire ohm circuit" [7] (also called a "4-wire Kelvin connection"). In any case it is a good engineering practice to keep the Wheatstone bridge voltage drive low enough to avoid the self heating of the strain gauge.