Ads
related to: cabling pull string
Search results
Results From The WOW.Com Content Network
Pullstring. Japanese spinning tops with pullstrings. A pullstring ( pull string, pull-string ), pullcord ( pull cord, pull-cord ), or pullchain ( pull-chain, pull chain) is a string, cord, or chain wound on a spring -loaded spindle that engages a mechanism when it is pulled. It is most commonly used in toys and motorized equipment.
The goal is to push toward an area where guide string has been dropped inside the confined space and to pull it through, so the guide string can then be used to pull through various types of wiring, such as phone wire, network cables or speaker wire. Fish tape is designed to pull through guide string only.
Cable harness. Harness of car audio cables. A cable harness, also known as a wire harness, wiring harness, cable assembly, wiring assembly or wiring loom, is an assembly of electrical cables or wires which transmit signals or electrical power. [ 1] The cables are bound together by a durable material such as rubber, vinyl, electrical tape ...
v. t. e. Knob-and-tube wiring (sometimes abbreviated K&T) is an early standardized method of electrical wiring in buildings, in common use in North America from about 1880 to the 1930s. [ 1][ 2] It consisted of single-insulated copper conductors run within wall or ceiling cavities, passing through joist and stud drill-holes via protective ...
Tension is the pulling or stretching force transmitted axially along an object such as a string, rope, chain, rod, truss member, or other object, so as to stretch or pull apart the object. In terms of force, it is the opposite of compression. Tension might also be described as the action-reaction pair of forces acting at each end of an object.
A common cable installation technique for fiber cables remains cable pulling. After the duct is placed, a high-strength pull line is blown into the duct (if one has not already been pre-installed by the duct manufacturer). The pull line is attached to one end of the cable and is used to pull the cable through the duct.
Jetting. Cable jetting is the process of blowing a cable through a duct while simultaneously pushing the cable into the duct. Compressed air is injected at the duct inlet and flows through the duct and along the cable at high speed. (Preferably, no suction pig is used at the cable head.) The high speed air propels the cable due to drag forces ...
Bowden cables controlling an automobile throttle. A Bowden cable ( / ˈboʊdən / BOH-dən) [ 1] is a type of flexible cable used to transmit mechanical force or energy by the movement of an inner cable relative to a hollow outer cable housing. The housing is generally of composite construction, consisting of an inner lining, a longitudinally ...
Ads
related to: cabling pull string