Search results
Results From The WOW.Com Content Network
Typically, after welding, the properties near the weld are those of 6061-T4, a loss of strength of around 40%. The material can be re-heat-treated to restore near -T6 temper for the whole piece. After welding, the material can naturally age and restore some of its strength as well. Most strength is recovered in the first few days to a few weeks.
Flame retardant. Open-flame tests compare the flammability of untreated polyurethane foam (top) and an identical foam sample surface treated with a sandwich-like coating incorporating layered double hydroxides. By 90 seconds after ignition the untreated foam is completely consumed. Flame retardants are a diverse group of chemicals that are ...
Polytetrafluoroethylene. Polytetrafluoroethylene ( PTFE) is a synthetic fluoropolymer of tetrafluoroethylene, and has numerous applications because it is chemically inert. The commonly known brand name of PTFE-based composition is Teflon by Chemours, [ 1] a spin-off from DuPont, which originally discovered the compound in 1938.
Polyurethane foam in the lower half of the mold in which it was made. When assembled into a car seat, this foam makes up the seat back. The forward-facing part of the seat back is the surface of the foam which is face-down in the mold. The two holes in the foam at the top of the picture are for the headrest posts.
EPDM rubber. EPDM rubber ( ethylene propylene diene monomer rubber) [ 1][ 2][ 3] is a type of synthetic rubber that is used in many applications. EPDM is an M-Class rubber under ASTM standard D-1418; the M class comprises elastomers with a saturated polyethylene chain (the M deriving from the more correct term polymethylene).
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
The heat deflection temperature or heat distortion temperature (HDT, HDTUL, or DTUL) is the temperature at which a polymer or plastic sample deforms under a specified load. [ 1] This property of a given plastic material is applied in many aspects of product design, engineering and manufacture of products using thermoplastic components.
The patient should remain in the ice bath until their body temperature falls to 102.2 degrees. Then, they can be transported to the hospital. Preparing for heat illness in a warming world